Thermal Analysis of a Firefighter’s Breathing Gas Cooler
Journal of the International Society for Respiratory Protection · 1997
DOI: 10.66828/001c.168248 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of the International Society for Respiratory Protection, 1997. Verfasst von M. L. Nuckols und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
A breathing gas cooler design is described to keep the life-support gas inside a firefighter’s face mask at, or below, 120°F for a period of at least 30 minutes. Two basic heat exchanger designs are evaluated for their thermal performances. Both designs incorporate a modification to the existing firefighter’s apparatus with MicroPCM™ wrapped around the breathing gas supply lines within a foamed metal matrix . The gas cooler designs, in the configuration of an air-to-liquid (or solid) heat exchanger, were designed to be worn comfortably by the firefighter and have quick connect and disconnect air supply fittings for ease of switch out. A 5 foot long, single pass heat exchanger, surrounded with a MicroPCM slurry in either a pig nose or bullseye configuration was found adequate to reduce a firefighter’s breathing gas from a temperature of 200°F to 120°F with a respiratory minute volume of 62.5 LPM. Both design configurations have foamed aluminum matrix in contact with the outside of the breathing gas tube to enhance the heat transfer from the breathing gas to the MicroPCM slurry. Eicosane, C20H42, with a melting temperature of 98.1°F was shown to be the best candidate MicroPCM for maximizing the heat transfer efficiency in the breathing gas cooler. Less than 2 pounds of a slurry consisting of 60% Eicosane, and 40% water was found to provide sufficient heat storage capacity to operate the breathing gas cooler for a 30 minute duration. The entire heat exchanger assembly weighed less than 5 pounds.
Zitieren
APA
Nuckols, M. L., Rudolph, J., & Hughes, R. J. (1997). Thermal Analysis of a Firefighter’s Breathing Gas Cooler. Journal of the International Society for Respiratory Protection. https://doi.org/10.66828/001c.168248
Vancouver
Nuckols ML, Rudolph J, Hughes RJ. Thermal Analysis of a Firefighter’s Breathing Gas Cooler. Journal of the International Society for Respiratory Protection. 1997. doi:10.66828/001c.168248
BibTeX
@article{Nuckols1997,
author = {Nuckols, M. L. and Rudolph, J. and Hughes, R. J.},
title = {Thermal Analysis of a Firefighter’s Breathing Gas Cooler},
journal = {Journal of the International Society for Respiratory Protection},
year = {1997},
doi = {10.66828/001c.168248}
}
EUVIMED