EUVIMEDEUVIMED entdecken
Crossref

Analysis of measurement problems of curvilinear profile specimen models produced by 3D printing

Dominik Malara

Mechatronics and Mechanical Engineering · 01.04.2026 · 1

DOI: 10.66176/mandme0001 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Mechatronics and Mechanical Engineering, online erschienen am 01.04.2026. Verfasst von Dominik Malara.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The development of modern manufacturing technologies requires the adaptation of measurement methods, which generates the problem of developing a new measurement strategy and an in-depth analysis of known measurement methods. The paper presents the results of an investigation into the measurement of the surface topography of models manufactured by Material Extrusion Technology (MEX). The measurement was carried out using three optical methods: - confocal, the interferometric, focus variation. The curved surface was analysed in its central part and in the rounded area, both concave and convex. The results showed significant differences in both measurement reliability and measurement errors. The results of the research showed that interferometry was the least effective method, characterised by the highest number of non-measured points regardless of the measurement location and sample shape. In contrast, the focus variation method showed the highest number of noise - spikes/ghost points located mainly at the edges of the measured area, which has a direct impact on the calculated value of the surface parameters. On average, the differences in the number of non-measured points for interferometric measurements were roughly four and a half times greater than for the confocal method and about one and a half times greater than for the focus variation method.

Zitieren

APA

Malara, D. (2026). Analysis of measurement problems of curvilinear profile specimen models produced by 3D printing. Mechatronics and Mechanical Engineering, 1. https://doi.org/10.66176/mandme0001

Vancouver

Malara D. Analysis of measurement problems of curvilinear profile specimen models produced by 3D printing. Mechatronics and Mechanical Engineering. 2026:1. doi:10.66176/mandme0001

BibTeX
@article{Malara2026,
  author = {Malara, Dominik},
  title = {Analysis of measurement problems of curvilinear profile specimen models produced by 3D printing},
  journal = {Mechatronics and Mechanical Engineering},
  year = {2026},
  pages = {1},
  doi = {10.66176/mandme0001}
}
Kostenlos starten →