EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-SA 4.0

Performance Analysis of Arduino DHT11 Sensor Libraries for Resource-constrained IoT/WoT Edge Nodes.

Hassan Hassan

Zanin Journal of Science and Engineering · 2026

DOI: 10.64362/zjse.261 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Zanin Journal of Science and Engineering, 2026. Verfasst von Hassan Hassan. Die Arbeit nennt 19 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-SA 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Efficient sensing remains critical in low-cost Internet of Things (IoT) and Web of Things (WoT)-enabled edge nodes, even when the sensor itself is inexpensive and widely used. The DHT11 temperature and humidity sensor employs a single-wire digital protocol and relies on Arduino libraries for data acquisition, timeout handling, and scheduling behavior. In this paper, eight Arduino DHT11 libraries are benchmarked on an Arduino Uno R3 using six criteria: flash memory usage, SRAM consumption, average measured call duration, timing variability, maximum CPU blocking time, and failure-recovery behavior. The results reveal substantial performance trade-offs. Average measured call durations ranged from 5,588 µs for the asynchronous DHT Sensors Non-Blocking implementation to approximately 1.04 s for DHT11; however, these measurements reflect different execution semantics and should not be interpreted as directly equivalent end-to-end acquisition latencies. Flash usage ranged from 4,288 to 5,244 bytes, while SRAM consumption ranged from 238 to 266 bytes. TroykaDHT and SDHT delivered the most stable low-latency readings, DFRobot_DHT11 minimized SRAM usage, and DHT Sensors Non-Blocking was most suitable when asynchronous execution and reduced continuous CPU occupation were required. This study does not directly benchmark application-layer protocols or cloud services, such as HTTP, MQTT, REST, or WebSocket; instead, it characterizes sensing-layer behavior that can influence data freshness, task scheduling, and overall responsiveness in re-source-constrained IoT/WoT edge deployments.

Zitieren

APA

Hassan, H. (2026). Performance Analysis of Arduino DHT11 Sensor Libraries for Resource-constrained IoT/WoT Edge Nodes. Zanin Journal of Science and Engineering. https://doi.org/10.64362/zjse.261

Vancouver

Hassan H. Performance Analysis of Arduino DHT11 Sensor Libraries for Resource-constrained IoT/WoT Edge Nodes. Zanin Journal of Science and Engineering. 2026. doi:10.64362/zjse.261

BibTeX
@article{Hassan2026,
  author = {Hassan, Hassan},
  title = {Performance Analysis of Arduino DHT11 Sensor Libraries for Resource-constrained IoT/WoT Edge Nodes},
  journal = {Zanin Journal of Science and Engineering},
  year = {2026},
  doi = {10.64362/zjse.261}
}
Kostenlos starten →