COMPARATIVE ASSESSMENT OF REFLECTIVE ROOF COATINGS FOR REDUCING COOLING LOADS IN HOT–ARID CLIMATES: A TRANSIENT HEAT–BALANCE STUDY FOR BAGHDAD, IRAQ
International Journal Multidisciplinary (IJMI) · 31.05.2026 · 3 (2) · 446-461
DOI: 10.61796/ijmi.v3i2.496 ↗Kurz gefasst
Fachartikel in der Zeitschrift International Journal Multidisciplinary (IJMI), online erschienen am 31.05.2026. Verfasst von Ehab Alaa Farhan und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Abstract (Originalsprache)
Objective
This study presents a model-based comparative assessment of five roof surface finishes—Standard Dark, White Reflective, Aluminum Metallic, Thermochromic, and Retro-Reflective—with respect to their ability to reduce cooling loads in buildings located in hot–arid climates.
Method
A transient heat–balance model for a flat commercial roof is implemented in Python and driven by Typical Meteorological Year (TMY) data for Baghdad International Airport, Iraq. The model resolves hourly exterior surface temperatures using a nonlinear energy balance that accounts for absorbed solar radiation, wind-dependent convection, longwave exchange with the sky, and conduction into the conditioned interior.
Results
For a 100 m² roof on a single-story commercial building maintained at 24 °C, the simulated annual roof-related conductive cooling load with a Standard Dark roof is 6268.2 kWh. Replacing this surface with a White Reflective coating reduces the annual roof-related conductive cooling load to 2888.7 kWh (53.9% savings for this specific roof and climate, near the upper end of ranges reported in the literature for reflective coatings in cooling-dominated regions). Assuming a typical cooling system coefficient of performance (COP) of 3.0, the corresponding electrical energy savings are approximately one-third of the thermal load reductions. Retro-Reflective and Thermochromic coatings yield annual roof-related conductive cooling loads of 3075.7 kWh (50.9% savings) and 3560.5 kWh (43.2% savings), respectively, while an Aluminum Metallic finish achieves 4562.8 kWh (27.2% savings). An economic evaluation incorporating a cooling system COP of 3.0 indicates that White Reflective coatings offer the shortest payback period (5.33 years) and the highest 10-year discounted net savings (134.7 USD) under current Iraqi electricity tariffs, followed by Aluminum Metallic, while Retro-Reflective and Thermochromic coatings show longer payback periods and negative net savings under the assumed conditions due to their higher initial costs relative to the electrical energy savings. Novelty: Advanced coating behaviors are represented through a temperature-dependent thermochromic reflectance function and a high-reflectance retro-reflective surface. A two-parameter sensitivity analysis demonstrates that both solar reflectance and thermal emittance exert strong, coupled influences on cooling load, with the lowest loads occurring for simultaneously high.
Zitieren
APA
Farhan, E. A., Alfatlawy, H. A. A., & Jasim, A. K. (2026). COMPARATIVE ASSESSMENT OF REFLECTIVE ROOF COATINGS FOR REDUCING COOLING LOADS IN HOT–ARID CLIMATES: A TRANSIENT HEAT–BALANCE STUDY FOR BAGHDAD, IRAQ. International Journal Multidisciplinary (IJMI), 3(2), 446-461. https://doi.org/10.61796/ijmi.v3i2.496
Vancouver
Farhan EA, Alfatlawy HAA, Jasim AK. COMPARATIVE ASSESSMENT OF REFLECTIVE ROOF COATINGS FOR REDUCING COOLING LOADS IN HOT–ARID CLIMATES: A TRANSIENT HEAT–BALANCE STUDY FOR BAGHDAD, IRAQ. International Journal Multidisciplinary (IJMI). 2026;3(2):446-461. doi:10.61796/ijmi.v3i2.496
BibTeX
@article{Farhan2026,
author = {Farhan, Ehab Alaa and Alfatlawy, Hassanin Abd Ali and Jasim, Ali. K.},
title = {COMPARATIVE ASSESSMENT OF REFLECTIVE ROOF COATINGS FOR REDUCING COOLING LOADS IN HOT–ARID CLIMATES: A TRANSIENT HEAT–BALANCE STUDY FOR BAGHDAD, IRAQ},
journal = {International Journal Multidisciplinary (IJMI)},
year = {2026},
volume = {3},
number = {2},
pages = {446--461},
doi = {10.61796/ijmi.v3i2.496}
}
EUVIMED