Comparative study between high performance polymers versus metallic definitive obturator: A finite element analysis
Mansoura Journal of Dentistry · 01.01.2026 · 13 (1)
DOI: 10.61793/2812-5479.1180 ↗Kurz gefasst
Fachartikel in der Zeitschrift Mansoura Journal of Dentistry, online erschienen am 01.01.2026. Verfasst von Mostafa S. Swedan. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Abstract (Originalsprache)
Aim
This study investigates the mechanical performance of obturators fabricated from PEKKTON, PEEK, and traditional Cobalet-chromium materials using finite element analysis.
Methods
One three dimensional finite element model was created for this study. Starting by cast laser scanning to create solid parts of the model "cortical, cancellous, mucosa, obturator, and partial denture" that to simulate restoration of maxillectomy defects. The model was subjected to average masticatory load of 200N distributed on the partial denture vertically and oblique.
Results
The results of the three obturator materials showed too similar deformation and stresses distributions with small variation in values. The obturator with highest rigidity and stiffness "CoCr" showed higher resistance to the applied load, specially the lateral component of the oblique load. The acrylic partial denture did not show considerable difference in both total deformation (of order 3.8 and 11.5 micron) nor von Mises stress (about 6.17 and 9.21 MPa) with changing obturators material under vertical and oblique loading cases respectively.
Conclusions
Within the study limitations, the obtained results within this study indicated that the three tested materials can be used. PEKKTON and PEEK as obturator materials showed too close results and better performance than CoCr one. That, it will not face failure even with increasing the applied load several times.
Zitieren
APA
Swedan, M. S. (2026). Comparative study between high performance polymers versus metallic definitive obturator: A finite element analysis. Mansoura Journal of Dentistry, 13(1). https://doi.org/10.61793/2812-5479.1180
Vancouver
Swedan MS. Comparative study between high performance polymers versus metallic definitive obturator: A finite element analysis. Mansoura Journal of Dentistry. 2026;13(1). doi:10.61793/2812-5479.1180
BibTeX
@article{Swedan2026,
author = {Swedan, Mostafa S.},
title = {Comparative study between high performance polymers versus metallic definitive obturator: A finite element analysis},
journal = {Mansoura Journal of Dentistry},
year = {2026},
volume = {13},
number = {1},
doi = {10.61793/2812-5479.1180}
}
EUVIMED