EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Rocking of single-layer armour units measured by embedded sensors

Bas Hofland, Daan Houtzager, Ganga Caldera, Alessandro Antonini, Marcel Van Gent, Pieter Bakker, Cock Van der Lem

Journal of Coastal and Hydraulic Structures · 2023

DOI: 10.59490/jchs.2023.0028 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Coastal and Hydraulic Structures, 2023. Verfasst von Bas Hofland und 6 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Single layer randomly placed armour units are used in many rubble mound breakwaters around the world. For these armour layers first extraction of units starts at high loads and can then progress quickly. Before the first extraction of a unit, typically no quantitative description of damage can be given. But additional to extraction, breakage of armour units due to rocking could be a major damage mechanism. This paper treat novel embedded Rocking Sensors. The technique is used to obtain the first measurements of rocking-impact velocities of single-layer units. They are also the first tests where the instrumented units can naturally move with the compacting layer during storm build-up. Physical model tests were performed on an armour layer with XBloc units. With 8 to 10 instrumented units per test run, in total 640 single measurements of the rocking motion of a unit during a 1200 wave test run were obtained, for three water levels and five wave heights. From the Rocking Sensors the number of impacts and rotational impact velocities were obtained. From an image analysis the along-slope settlement of the units during the tests was quantified. The rotational motion expressed by was found to be most convenient to express the motion. It can be seen that the units in the armour layer rock much more often than visually observed. Settlement seems to be a continuous progress, with most units rocking intermittently. Highest impact velocities are seen to occur around the water line, and in the uprush phase of the waves. A maximum impact velocity for all tests of 0.34 m/s (model scale) was measured. A preliminary design expression for rocking impact velocities of single layer units (Xblocs) is given. The paper shows that novel measurement techniques like the Rocking Sensors and vision techniques can and should be used to quantify damage mechanisms to rubble mound single-layer armour, additional to counting the extracted number of intact units.

Zitieren

APA

Hofland, B., Houtzager, D., Caldera, G., Antonini, A., Gent, M. V., Bakker, P., & Lem, C. V. D. (2023). Rocking of single-layer armour units measured by embedded sensors. Journal of Coastal and Hydraulic Structures. https://doi.org/10.59490/jchs.2023.0028

Vancouver

Hofland B, Houtzager D, Caldera G, Antonini A, Gent MV, Bakker P, et al. Rocking of single-layer armour units measured by embedded sensors. Journal of Coastal and Hydraulic Structures. 2023. doi:10.59490/jchs.2023.0028

BibTeX
@article{Hofland2023,
  author = {Hofland, Bas and Houtzager, Daan and Caldera, Ganga and Antonini, Alessandro and Gent, Marcel Van and Bakker, Pieter and Lem, Cock Van der},
  title = {Rocking of single-layer armour units measured by embedded sensors},
  journal = {Journal of Coastal and Hydraulic Structures},
  year = {2023},
  doi = {10.59490/jchs.2023.0028}
}
Kostenlos starten →