EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

ARDUINO UNO DIGITAL DISPLAY SYSTEM FOR AUTOMOBILE BATTERY VOLTAGE AND CURRENT MONITORING

Leonardo Pasla, Yohanis Prasetyo Dalekes, Jeditjah Naapia Tamedi, Tammy Tinny Veisy Pangow, Alfred Noufie Mekel Mekel

EDUCATIONE · 10.08.2026 · 1173-1184

DOI: 10.59397/edu.v4i2.279 ↗

Kurz gefasst

Fachartikel in der Zeitschrift EDUCATIONE, online erschienen am 10.08.2026. Verfasst von Leonardo Pasla und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Automobile batteries require practical monitoring of voltage and current to support early identification of abnormal operating conditions. This study aimed to design and implement an Arduino Uno-based digital display system for monitoring a nominal 12 V automobile battery. The prototype integrates a resistor-divider voltage sensor, an ACS712-20A current sensor, an LM2596 DC-DC converter, a 16×2 I2C liquid-crystal display, and a buzzer. A Research and Development approach organized as an engineering design cycle was used, covering system design, prototype assembly, functional testing, and evaluation. Voltage readings were compared with a digital multimeter at five test points and produced a mean absolute percentage error of 0.38%. Current readings were examined under five charging and discharging conditions and produced a mean absolute percentage error of 3.61%; the largest relative deviation occurred at the lowest-magnitude discharge point. The buzzer remained off at 11.50 V and activated below 11.50 V, confirming the programmed comparator logic. The findings support the prototype as a simple continuous voltage-current and status monitoring device under the tested conditions. The study does not establish direct ampere-hour capacity or validated state-of-charge estimation; further validation with calibrated reference instruments, repeated measurements, multiple batteries, environmental variation, and dynamic automotive loads is required.

Zitieren

APA

Pasla, L., Dalekes, Y. P., Tamedi, J. N., Pangow, T. T. V., & Mekel, A. N. M. (2026). ARDUINO UNO DIGITAL DISPLAY SYSTEM FOR AUTOMOBILE BATTERY VOLTAGE AND CURRENT MONITORING. EDUCATIONE, 1173-1184. https://doi.org/10.59397/edu.v4i2.279

Vancouver

Pasla L, Dalekes YP, Tamedi JN, Pangow TTV, Mekel ANM. ARDUINO UNO DIGITAL DISPLAY SYSTEM FOR AUTOMOBILE BATTERY VOLTAGE AND CURRENT MONITORING. EDUCATIONE. 2026:1173-1184. doi:10.59397/edu.v4i2.279

BibTeX
@article{Pasla2026,
  author = {Pasla, Leonardo and Dalekes, Yohanis Prasetyo and Tamedi, Jeditjah Naapia and Pangow, Tammy Tinny Veisy and Mekel, Alfred Noufie Mekel},
  title = {ARDUINO UNO DIGITAL DISPLAY SYSTEM FOR AUTOMOBILE BATTERY VOLTAGE AND CURRENT MONITORING},
  journal = {EDUCATIONE},
  year = {2026},
  pages = {1173--1184},
  doi = {10.59397/edu.v4i2.279}
}
Kostenlos starten →