3D design and implementation of simulations before the prototype development: Importance of circular economy input elements
Journal of Engineering Management and Competitiveness · 2026 · 16 (1) · 95-106
DOI: 10.5937/jemc2600006v ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Engineering Management and Competitiveness, 2026. Verfasst von Miloš Vorkapić und 4 weiteren Autor:innen. Die Arbeit nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-SA 4.0). Gefördert von: Ministry of Education, Science and Technological Development of the Republic of Serbia.
Abstract (Originalsprache)
This paper examines the numerical simulation within the circular economy framework. The numerical simulation of an electronics enclosure was analysed in two cases. The first case referred to the FEM analysis of the enclosure behavior under a uniform load applied to the cover and to the connection between the cover and the central part. Additionally, the impact of the enclosure striking a hard surface and its behavior after a fall were evaluated. The second direction concerned the application of the Slicer software platform, and the printing parameters were also defined. All preparations were made before the prototype was implemented. So, during design and after simulations, the designer can adjust the model's dimensions or redesign the existing product. This paper describes the strategy that designers should apply in the implementation of the redesigned product. Numerical simulations as an input element of CE reduce the risk of failed prototypes, and their importance is reflected in the rapid prototyping without loss of material or consumption of other resources, reliable analysis of prototypes, identification of critical zones, and the possibility of recycling planning. For comprehensive analysis and product certification, experimental testing and the use of recycled materials are required.
Förderung
- Ministry of Education, Science and Technological Development of the Republic of Serbia
Zitieren
APA
Vorkapić, M., Jovanović, A., Vasić, M., Tanović, D., & Đalić, N. (2026). 3D design and implementation of simulations before the prototype development: Importance of circular economy input elements. Journal of Engineering Management and Competitiveness, 16(1), 95-106. https://doi.org/10.5937/jemc2600006v
Vancouver
Vorkapić M, Jovanović A, Vasić M, Tanović D, Đalić N. 3D design and implementation of simulations before the prototype development: Importance of circular economy input elements. Journal of Engineering Management and Competitiveness. 2026;16(1):95-106. doi:10.5937/jemc2600006v
BibTeX
@article{Vorkapi2026,
author = {Vorkapić, Miloš and Jovanović, Aleksandar and Vasić, Miloš and Tanović, Dragoljub and Đalić, Nataša},
title = {3D design and implementation of simulations before the prototype development: Importance of circular economy input elements},
journal = {Journal of Engineering Management and Competitiveness},
year = {2026},
volume = {16},
number = {1},
pages = {95--106},
doi = {10.5937/jemc2600006v}
}
EUVIMED