Scan induction hardening of S45C steel: The effect of scan speed on hardness and hardening depth
Journal of Applied Engineering Science · 2026 · 24 (4) · 805-814
DOI: 10.5937/jaes0-71221 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Applied Engineering Science, 2026. Verfasst von Padang Yanuar und 4 weiteren Autor:innen. Die Arbeit nennt 20 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This study aims to characterise the effect of scan speed on surface hardness and hardness distribution with depth in medium carbon steel S45C. The process is carried out using a static induction coil, while the workpiece with a diameter of 29 mm moves in both rotation and translation, followed by a quenching process. A total of 11 specimens were tested at a scan speed of 3.33-5.00 mm/s. Surface hardness was evaluated using the Rockwell C scale, while the hardness profile against depth was analysed using the Vickers method. The results show that the highest average hardness was obtained in Specimen 9 at 53.68 HRC at a speed of 3.66 mm/s, while Specimen 11 showed the best stability with an average of 53.00 HRC and a coefficient of variation of 4.27% at 3.53 mm/s. An increase in speed up to 4.69-5.00 mm/s tends to decrease surface hardness. The Vickers profile shows values of 544-637 HV in the near-surface area, then significantly decreases at a depth of about 1-2.5 mm and approaches 180-225 HV in the deeper sections. These results indicate the formation of a hardening gradient from the surface layer towards the transition zone and core. Overall, a scan speed of around 3.5-3.7 mm/s provides the best combination of hardness level, hardening response depth, and process stability in the experimental configuration used.
Zitieren
APA
Yanuar, P., Nugroho, S., Ismail, R., Mustofa, R., & Yanuar, M. (2026). Scan induction hardening of S45C steel: The effect of scan speed on hardness and hardening depth. Journal of Applied Engineering Science, 24(4), 805-814. https://doi.org/10.5937/jaes0-71221
Vancouver
Yanuar P, Nugroho S, Ismail R, Mustofa R, Yanuar M. Scan induction hardening of S45C steel: The effect of scan speed on hardness and hardening depth. Journal of Applied Engineering Science. 2026;24(4):805-814. doi:10.5937/jaes0-71221
BibTeX
@article{Yanuar2026,
author = {Yanuar, Padang and Nugroho, Sri and Ismail, Rifky and Mustofa, Rizal and Yanuar, Mahfudz},
title = {Scan induction hardening of S45C steel: The effect of scan speed on hardness and hardening depth},
journal = {Journal of Applied Engineering Science},
year = {2026},
volume = {24},
number = {4},
pages = {805--814},
doi = {10.5937/jaes0-71221}
}
EUVIMED