Finite element analysis of a combined cultivator working unit with rear roller under limit loading
Journal of Applied Engineering Science · 2026 · 24 (4) · 648-657
DOI: 10.5937/jaes0-66040 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Applied Engineering Science, 2026. Verfasst von Galin Tihanov und 3 weiteren Autor:innen. Die Arbeit nennt 19 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This study presents a structural safety assessment of a combined cultivator working unit comprising cultivator tines and a rear roller using the finite element method (FEM). A three-dimensional model of the structure was developed in the SolidWorks CAD environment and analyzed in SolidWorks Simulation under linear static conditions. Three tine configurations were investigated according to their cross-sectional geometry-circular, square, and rhomboidal-using the same assigned material properties and nominal pressure levels. Soil-tool interaction was simplified by applying a uniformly distributed pressure over the active contact surfaces of the tines and the rear roller. The analysis focused on the highest prescribed pressure of 2.5 kgf/cm² (approximately 0.2452 MPa, reported as 0.25 MPa), adopted as a reference loading scenario for comparative structural assessment. The assessment was carried out using equivalent von Mises stresses, total displacements, and the factor of safety (FOS). The results showed differences in the calculated structural response of the three configurations, including local exceedance of the specified yield criterion for the rhomboidal configuration and the largest resultant displacement for the circular configuration. The analysis evaluated the structural response of the complete assembly, including the cultivator tines, supporting structure, and rear roller. The findings provide a basis for comparing the calculated stresses, displacements, and safety margins of the investigated configurations under the prescribed static loading conditions.
Zitieren
APA
Tihanov, G., Hristova, G., Peychev, K., & Stoyanov, Y. (2026). Finite element analysis of a combined cultivator working unit with rear roller under limit loading. Journal of Applied Engineering Science, 24(4), 648-657. https://doi.org/10.5937/jaes0-66040
Vancouver
Tihanov G, Hristova G, Peychev K, Stoyanov Y. Finite element analysis of a combined cultivator working unit with rear roller under limit loading. Journal of Applied Engineering Science. 2026;24(4):648-657. doi:10.5937/jaes0-66040
BibTeX
@article{Tihanov2026,
author = {Tihanov, Galin and Hristova, Galya and Peychev, Kancho and Stoyanov, Yordan},
title = {Finite element analysis of a combined cultivator working unit with rear roller under limit loading},
journal = {Journal of Applied Engineering Science},
year = {2026},
volume = {24},
number = {4},
pages = {648--657},
doi = {10.5937/jaes0-66040}
}
EUVIMED