EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Deformation behavior and failure conditions in pneumatic bulge forming using circular and elliptical dies

Hamid Ali, Obeed Balod, Ataalah Jassim

FME Transactions · 2026 · 54 (3) · 537-548

DOI: 10.5937/fme2603537h ↗

Kurz gefasst

Fachartikel in der Zeitschrift FME Transactions, 2026. Verfasst von Hamid Ali und 2 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The deformation and failure behavior of AA1050 aluminum sheet during warm pneumatic bulge forming (PBF) were investigated experimentally and numerically using circular and elliptical dies. The simulations were performed in Abaqus/Explicit using the Johnson-Cook (JC) model at 300 °C under constant pressure levels. The results showed that the die aspect ratio has a strong effect on deformation and failure. The circular die led to more uniform biaxial deformation and high dome height, while elliptical dies caused non-uniform deformation and strain localization along the major axis. The failure occurred in the region of maximum thinning, where a crack extended along the major axis. The crack was small and located at the dome apex in the circular die, while in the elliptical dies, it became longer and more extended. The formability improved with increasing the sheet thickness (STH) from 0.7 mm to 1 mm, allowing higher strain and dome height before failure.

Zitieren

APA

Ali, H., Balod, O., & Jassim, A. (2026). Deformation behavior and failure conditions in pneumatic bulge forming using circular and elliptical dies. FME Transactions, 54(3), 537-548. https://doi.org/10.5937/fme2603537h

Vancouver

Ali H, Balod O, Jassim A. Deformation behavior and failure conditions in pneumatic bulge forming using circular and elliptical dies. FME Transactions. 2026;54(3):537-548. doi:10.5937/fme2603537h

BibTeX
@article{Ali2026,
  author = {Ali, Hamid and Balod, Obeed and Jassim, Ataalah},
  title = {Deformation behavior and failure conditions in pneumatic bulge forming using circular and elliptical dies},
  journal = {FME Transactions},
  year = {2026},
  volume = {54},
  number = {3},
  pages = {537--548},
  doi = {10.5937/fme2603537h}
}
Kostenlos starten →