Determination of ivermectin in 3D-printed tablets by high-performance liquid chromatography: Method development and validation
Arhiv za farmaciju · 2026 · 76 (5) · 298-313
DOI: 10.5937/arhfarm76-69860 ↗Kurz gefasst
Fachartikel in der Zeitschrift Arhiv za farmaciju, 2026. Verfasst von Milan Selaković und 4 weiteren Autor:innen. Die Arbeit nennt 17 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-SA 4.0). Gefördert von: Ministry of Education, Science and Technological Development of the Republic of Serbia.
Abstract (Originalsprache)
A simple isocratic reversed-phase high-performance liquid chromatographic method was developed and validated for the determination of ivermectin in tablets prepared by three-dimensional printing. Separation was achieved on a hexyl-phenyl column (150 × 4.6 mm, 5 µm) with a mobile phase composed of 0.1% orthophosphoric acid and acetonitrile (40:60, V/V), a flow rate of 1.0 mL/min, a column temperature of 30 °C and ultraviolet detection at 240 nm. Ivermectin eluted at 4.04 min and no interference from placebo components was observed. The method was linear in the range 0.0015-0.0045 mg/mL (r = 0.9996), with a statistically insignificant intercept. Repeatability, expressed as relative standard deviation, was below 2% at all three concentration levels, and recovery from spiked placebo mixtures ranged from 99.17% to 101.67%. Deliberate small variations in the acetonitrile content of the mobile phase and in the column temperature did not alter the peak area of ivermectin by more than 5%, confirming robustness. The validated method was applied to 3D-printed tablets; contents of 99.53% and 101.15% of the label claim were obtained by the calibration curve and external standard procedures, respectively, with no statistically significant difference between them.
Förderung
- Ministry of Education, Science and Technological Development of the Republic of Serbia
Zitieren
APA
Selaković, M., Ranković, T., Nedeljković, S., Stamenković, M., & Ivković, B. (2026). Determination of ivermectin in 3D-printed tablets by high-performance liquid chromatography: Method development and validation. Arhiv za farmaciju, 76(5), 298-313. https://doi.org/10.5937/arhfarm76-69860
Vancouver
Selaković M, Ranković T, Nedeljković S, Stamenković M, Ivković B. Determination of ivermectin in 3D-printed tablets by high-performance liquid chromatography: Method development and validation. Arhiv za farmaciju. 2026;76(5):298-313. doi:10.5937/arhfarm76-69860
BibTeX
@article{Selakovi2026,
author = {Selaković, Milan and Ranković, Tamara and Nedeljković, Sara and Stamenković, Matija and Ivković, Branka},
title = {Determination of ivermectin in 3D-printed tablets by high-performance liquid chromatography: Method development and validation},
journal = {Arhiv za farmaciju},
year = {2026},
volume = {76},
number = {5},
pages = {298--313},
doi = {10.5937/arhfarm76-69860}
}
EUVIMED