EUVIMEDEUVIMED entdecken
Open Access · CC BY-SA 4.0

Field-Validated Triplen Harmonic and Neutral Current Mitigation Using an Active Harmonic Filter

Zakky Daniel Haq, Kuntjoro Pinardi, Abdul Multi

International Journal of Engineering Continuity · 03.08.2026 · 5 (2) · 23-51

DOI: 10.58291/ijec.v5i2.626 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Journal of Engineering Continuity, online erschienen am 03.08.2026. Verfasst von Zakky Daniel Haq und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-SA 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Nonlinear loads in commercial buildings increasingly distort low-voltage distribution systems and may cause excessive neutral-current loading. Third-order triplen harmonics are especially critical in three-phase four-wire systems because their zero-sequence components accumulate in the neutral conductor instead of cancelling among phases. Despite extensive harmonic research, few field-based studies jointly quantify triplen-driven neutral loading, verify Active Harmonic Filter (AHF) performance on an operating commercial site, and confirm IEEE Std 519-2022 compliance within a single case, leaving a practical evidence gap. This paper presents a field-validated assessment of triplen harmonic mitigation in a commercial building distribution system using a shunt Active Harmonic Filter (AHF). Field measurements were obtained at the incoming side of the SDP Amazon Atrium Senen distribution panel using a power quality analyzer, and the results were evaluated using IEEE Std 519-2022. A MATLAB/Simulink model was developed to represent the measured operating condition and support performance interpretation. The model was validated against the field data—accurate for voltage distortion and power factor but under-predicting current distortion—so it is positioned as a trend-analysis rather than a sizing tool. The pre-mitigation condition showed severe current distortion, with phase-current THDi values of 69.27%, 81.47%, and 56.28%, a voltage THD of 5.40%, a neutral current of 96.89 A, and a power factor of 0.82. After AHF operation, the THDi values decreased to 9.87%, 12.18%, and 8.46%, while THDv decreased to 3.35%, neutral current decreased to 23.41 A, and power factor increased to 0.99. Whereas conventional THDi and TDD indices quantify overall distortion but not the zero-sequence burden carried by the neutral conductor, this study introduces a dedicated metric for that burden. The proposed Neutral Harmonic Mitigation Ratio (NHMR) reached 75.84%, indicating substantial reduction of triplen-related neutral loading. Evaluated through Total Demand Distortion under the measured short-circuit ratio, the post-mitigation condition satisfied the IEEE Std 519-2022 current-distortion limit. The results show that a field-validated AHF approach can effectively mitigate triplen harmonic effects and improve power quality in commercial three-phase four-wire distribution systems. Beyond the numerical gains, the field-validated framework gives facility engineers a practical, standards-referenced basis for diagnosing neutral-current risk and planning AHF-based mitigation in commercial power systems.

Zitieren

APA

Haq, Z. D., Pinardi, K., & Multi, A. (2026). Field-Validated Triplen Harmonic and Neutral Current Mitigation Using an Active Harmonic Filter. International Journal of Engineering Continuity, 5(2), 23-51. https://doi.org/10.58291/ijec.v5i2.626

Vancouver

Haq ZD, Pinardi K, Multi A. Field-Validated Triplen Harmonic and Neutral Current Mitigation Using an Active Harmonic Filter. International Journal of Engineering Continuity. 2026;5(2):23-51. doi:10.58291/ijec.v5i2.626

BibTeX
@article{Haq2026,
  author = {Haq, Zakky Daniel and Pinardi, Kuntjoro and Multi, Abdul},
  title = {Field-Validated Triplen Harmonic and Neutral Current Mitigation Using an Active Harmonic Filter},
  journal = {International Journal of Engineering Continuity},
  year = {2026},
  volume = {5},
  number = {2},
  pages = {23--51},
  doi = {10.58291/ijec.v5i2.626}
}
Kostenlos starten →