Development of Magnetic Flux Leakage Sensor for Local Damage Detection in Chain
e-Journal of Nondestructive Testing · 2026-08 · 31 (8)
DOI: 10.58286/33951 ↗Kurz gefasst
Fachartikel in der Zeitschrift e-Journal of Nondestructive Testing, 2026-08. Verfasst von Eun-Yul Lee und 3 weiteren Autor:innen.
Abstract (Originalsprache)
The Chain is discontinuous structures component widely used as critical components for power transmission and load bearing in various industrial facilities. However, local damage caused by repeated loading, friction, corrosion, and fatigue cracking can lead to catastrophic chain failure and unexpected equipment shutdown, resulting in severe safety risks. Accordingly, the objective of this research is to prevent chain failure-induced accidents by designing a Magnetic Flux Leakage (MFL) sensing system and experimentally verifying its capability to detect early-stage localized damage. To achieve this, an MFL sensor was designed to detect local damage non-destructively. A magnetization unit consisting of Neodymium permanent magnets and carbon steel yokes was applied to magnetically saturate the chain, and an array of 8-channel Hall sensors (positioned on the top and bottom) measured the leakage flux signals generated from the damaged areas. An experimental chain specimen of 3 m length with artificially machined defect depths between 1–4 mm is prepared, and leakage-flux measurement is repeated 400 times per damage level using a DAQ board for high-speed sequence acquisition. Because the acquired leakage sequence includes electrical noise and magnetization-induced baseline drift, a moving-average-based detrending method is applied to suppress non-diagnostic low-frequency components while preserving defect-related modulation. Fast Fourier Transform (FFT) analysis is performed to project the spatial magnetic leakage pattern into the frequency domain. Damage-governed spectral peaks that grow distinctly with defect severity emerge within constrained frequency bands, and these peaks are designated as core defect-signature frequency components. A band-pass filter retains only these core components, and Inverse FFT (IFFT) reconstructs them back to the spatial distance domain for direct visual confirmation of defect localization and severity-dependent amplitude variation. This study is expected to enhance the efficiency and reliability of chain maintenance and diagnosis through the design, fabrication, and verification of the MFL sensor. Consequently, this research contributes to the advancement of the Structural Health Monitoring (SHM) field.
Zitieren
APA
Lee, E., Kyung, S., Lee, H., & Kim, J. (2026). Development of Magnetic Flux Leakage Sensor for Local Damage Detection in Chain. e-Journal of Nondestructive Testing, 31(8). https://doi.org/10.58286/33951
Vancouver
Lee E, Kyung S, Lee H, Kim J. Development of Magnetic Flux Leakage Sensor for Local Damage Detection in Chain. e-Journal of Nondestructive Testing. 2026;31(8). doi:10.58286/33951
BibTeX
@article{Lee2026,
author = {Lee, Eun-Yul and Kyung, Sae-Byeok and Lee, Ho-Jun and Kim, Ju-Won},
title = {Development of Magnetic Flux Leakage Sensor for Local Damage Detection in Chain},
journal = {e-Journal of Nondestructive Testing},
year = {2026},
volume = {31},
number = {8},
doi = {10.58286/33951}
}
EUVIMED