Opto-electronic system for ultrasonic waves measurement using Fiber Bragg Gratings sensors
e-Journal of Nondestructive Testing · 2026-08 · 31 (8)
DOI: 10.58286/33811 ↗Kurz gefasst
Fachartikel in der Zeitschrift e-Journal of Nondestructive Testing, 2026-08. Verfasst von Théo Duval und 8 weiteren Autor:innen.
Abstract (Originalsprache)
One of the current challenges in Structural Health Monitoring (SHM) is the validation of new processing algorithms and the development of new methods. To achieve this, it is relevant to have complete control over the entire chain, from instrumentation to processing algorithms. To address this challenge, CEA List has developed an opto-electronic acquisition system using Fiber Bragg Gratings (FBGs) to measure ultrasonic waves. This system called “Optogero” has seven optical channels to enable simultaneous interrogation of multiple gratings. (cf. Figure 1). In several SHM applications, FBGs offer numerous advantages over the more commonly used piezoelectric transducers (PZT). For instance, they can operate at much higher temperatures (above 1,000°C) than conventional PZT (around 200°C). Optical fibers can also be integrated directly into a structure with very limited intrusiveness. However, the interrogation of FBGs presents several technical challenges, and their sensitivity currently remains lower than that of PZTs. The Optogero optoelectronic interrogation system is based on the edge-filtering measurement method. It can scan up to 7 Bragg gratings in parallel to identify their optimal operating point in order to maximize their sensitivity to ultrasonic waves. Real-time control of the laser source wavelength eliminates the consequences of varying environmental conditions, such as quasi-static strain and temperature changes in the structure. These effects would otherwise alter the response of the FBG and drive it away from the optimal operating point of the system. Various analog and digital processing techniques are integrated into the system to improve the signal to noise ratio. The Optogero system also includes a middleware architecture that allows users to easily embed data processing algorithms (imaging, artificial intelligence) for specific applications. The system has been tested over a two-year period in the laboratory to validate its operation. Measurements were done on various materials such as aluminum, polymer-based composites or concrete, using several different testing methods (acoustic emission measurements, guided wave imaging, at room temperature and high temperatures). We will present the operating principles of Optogero and the system's performance in a few representative use cases.
Zitieren
APA
Duval, T., Albertini, J., Gallet, A., Roussel, N., Fisher, C., Recoquillay, A., Carpine, R., Chapuis, B., & Laffont, G. (2026). Opto-electronic system for ultrasonic waves measurement using Fiber Bragg Gratings sensors. e-Journal of Nondestructive Testing, 31(8). https://doi.org/10.58286/33811
Vancouver
Duval T, Albertini J, Gallet A, Roussel N, Fisher C, Recoquillay A, et al. Opto-electronic system for ultrasonic waves measurement using Fiber Bragg Gratings sensors. e-Journal of Nondestructive Testing. 2026;31(8). doi:10.58286/33811
BibTeX
@article{Duval2026,
author = {Duval, Théo and Albertini, Julien and Gallet, Antoine and Roussel, Nicolas and Fisher, Clément and Recoquillay, Arnaud and Carpine, Raphaël and Chapuis, Bastien and Laffont, Guillaume},
title = {Opto-electronic system for ultrasonic waves measurement using Fiber Bragg Gratings sensors},
journal = {e-Journal of Nondestructive Testing},
year = {2026},
volume = {31},
number = {8},
doi = {10.58286/33811}
}
EUVIMED