EUVIMEDEUVIMED entdecken
Crossref

Impact Identification in Thin-Walled Structures Using Time Reversal of Guided Waves

Nikolaos Papanikolaou, Cecilia Saccone, Lotfollah Pahlavan

e-Journal of Nondestructive Testing · 2026-08 · 31 (8)

DOI: 10.58286/33705 ↗

Kurz gefasst

Fachartikel in der Zeitschrift e-Journal of Nondestructive Testing, 2026-08. Verfasst von Nikolaos Papanikolaou und 2 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Structures operating in complex marine environments are exposed to potential impacts from various external sources. Such events can result in significant structural or environmental consequences and may interrupt normal operations. Therefore, accurate impact identification is essential to ensure safety, minimize environmental risks, protect assets, and support informed decisions in structural integrity assessment. Impacts release part of their energy in the form of stress waves that in thin-walled structures such as ship hulls, propagate long distances as Guided Waves (GWs). The time reversibility and spatial reciprocity properties of the GUW allow the use of Time Reversal (TR) process of the recorded wave signals to localize impacts. The objective of this paper is to investigate impact localization and force reconstruction on steel plates and stiffened panels by means of monitoring impact induced GWs. To achieve this, an analytical framework has been developed and experimentally evaluated. The experimental part consists of generation of controlled impacts with an instrumented hammer. The stress waves emitted during impact were subsequently measured using surface mounted piezoelectric sensors with a resonant frequency of 60 kHz. Impact localization was performed through a virtual TR process which was implemented in the frequency domain using an analytical propagation formulation that accounts for dispersion and wave amplitude decay due to geometric spreading. Force reconstruction is achieved using a parametric half-sine model combined with a transfer function obtained from a single calibration impact. The approach was validated through small-scale experiments on steel plates and stiffened plates measuring 400x400 mm2. The average localization error for the plate ranged from 11 to 15 mm, while stiffened panel tests showed slightly higher errors in the order of 12 to 24 mm due to wave scattering at the stiffener. These results show that accurate localization is achievable. The reconstructed forces using the parametric model provide a good estimate of the applied impact force, with a mean relative error of approximately 24%. The results demonstrate that the proposed framework can enable combined impact localization and force estimation in thin-walled structures, with and without the presence of structural stiffeners.

Zitieren

APA

Papanikolaou, N., Saccone, C., & Pahlavan, L. (2026). Impact Identification in Thin-Walled Structures Using Time Reversal of Guided Waves. e-Journal of Nondestructive Testing, 31(8). https://doi.org/10.58286/33705

Vancouver

Papanikolaou N, Saccone C, Pahlavan L. Impact Identification in Thin-Walled Structures Using Time Reversal of Guided Waves. e-Journal of Nondestructive Testing. 2026;31(8). doi:10.58286/33705

BibTeX
@article{Papanikolaou2026,
  author = {Papanikolaou, Nikolaos and Saccone, Cecilia and Pahlavan, Lotfollah},
  title = {Impact Identification in Thin-Walled Structures Using Time Reversal of Guided Waves},
  journal = {e-Journal of Nondestructive Testing},
  year = {2026},
  volume = {31},
  number = {8},
  doi = {10.58286/33705}
}
Kostenlos starten →