Thermal and Hydraulic Performance Analysis of a Waste Heat Recovery Device for Domestic Furnace Exhaust Gases
Green Energy and Environmental Technology · 11.03.2026 · 5
DOI: 10.5772/geet.20250159 ↗Kurz gefasst
Fachartikel in der Zeitschrift Green Energy and Environmental Technology, online erschienen am 11.03.2026. Verfasst von Muhammad Tauseef und 1 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This study experimentally investigates the steady-state thermal and hydraulic performance of a waste heat recovery device (WHRD) designed to extract heat from non-condensed domestic heating furnaces to preheat the main water supply. The device was tested under varying water flow rates (0.5–2.5 GPM) while maintaining a constant hot gas flow rate of 34 m 3 /hr (20 CFM) at 90°C. Single- and multi-pass hot gas flow configurations were examined within the same external dimensions of the WHRD. The performance was analyzed using the effectiveness and total pressure drop. Results showed that the WHRD effectiveness decreases with increasing water flow rate, following trends typical of a standard counterflow heat exchanger. A maximum effectiveness of 38% was achieved at 1 GPM in the four-pass configuration. The hydraulic analysis of the WHRD found a maximum pressure drop of about 1.49 kPa at a 30 CFM hot gas flow rate in the four-pass flow configuration. This performance underscores how waste-heat recovery technologies could accelerate building-sector decarbonization by demonstrating substantial potential for annual energy savings and CO 2 emission reduction in residential heating applications. The findings provide valuable insight into optimizing WHRD designs for residential energy efficiency and support sustainable building practices.
Zitieren
APA
Tauseef, M., & Sharqawy, M. H. (2026). Thermal and Hydraulic Performance Analysis of a Waste Heat Recovery Device for Domestic Furnace Exhaust Gases. Green Energy and Environmental Technology, 5. https://doi.org/10.5772/geet.20250159
Vancouver
Tauseef M, Sharqawy MH. Thermal and Hydraulic Performance Analysis of a Waste Heat Recovery Device for Domestic Furnace Exhaust Gases. Green Energy and Environmental Technology. 2026;5. doi:10.5772/geet.20250159
BibTeX
@article{Tauseef2026,
author = {Tauseef, Muhammad and Sharqawy, Mostafa H.},
title = {Thermal and Hydraulic Performance Analysis of a Waste Heat Recovery Device for Domestic Furnace Exhaust Gases},
journal = {Green Energy and Environmental Technology},
year = {2026},
volume = {5},
doi = {10.5772/geet.20250159}
}
EUVIMED