EUVIMEDEUVIMED entdecken
Open Access · CC BY-SA 4.0

Quantification and Health Assessment of Microfiber Contamination in Selected Textile Processing Units of Punjab, Pakistan

Maham Maqbool, Azhar Ali, Malik Mansoor Ahmad, Maheen Mujeeb, Muhammad Zeeshan Ali

Pakistan Journal of Science · 31.12.2025 · 77 (04) · 568-576

DOI: 10.57041/91sa3b28 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Pakistan Journal of Science, online erschienen am 31.12.2025. Verfasst von Maham Maqbool und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-SA 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Microfibers (MFs) constitute small pieces of plastics produced as byproducts during the production processes of commercial products and further degradation of bulk polymers. Environmental impacts, as well as the hazard to biodiversity, are both threatened by MF pollution. Microfibers with vast utilization in the textile sector pose severe environmental and worker’s health concerns in many units of Punjab. This study aims to assess the microfiber's exposure and health risk in various textile industries in Punjab. Air and water samples were taken from inside and outside of selected textile industries in the Punjab province. Fourier Transform Infrared (FTIR) Spectroscopy was also used for the identification of microfiber polymers. Hazard index was calculated for over health risk of microfiber pollution. The results revealed that the highest concentration of microfibers was detected in Sheikhupura’s textile industries followed by Lahore. Among all the sections of textile industries, knitting section exhibited the highest microfiber detection /concentration. Hazard index values for air exposure in all the sections were below 1, except knitting section. Knitting section exhibited hazard index value of 1.26, indicating a potential health risk. Hazard index for wastewater and drinking water remained below 0, suggesting safe exposure levels. FTIR analyses revealed the type of MFs such as polybutylene terephthalate (3.13%), polypropylene standard (28.13%), polyisobutylene (12.5%), vinyl chloride (12.5%), polyethylene terephthalate (31.25%), low density polyethylene (3.13), and polyesters (9.38%). The most widespread were polypropylene and polyethylene terephthalate, the ones mostly utilized in various daily-use products all over the globe.

Zitieren

APA

Maqbool, M., Ali, A., Ahmad, M. M., Mujeeb, M., & Ali, M. Z. (2025). Quantification and Health Assessment of Microfiber Contamination in Selected Textile Processing Units of Punjab, Pakistan. Pakistan Journal of Science, 77(04), 568-576. https://doi.org/10.57041/91sa3b28

Vancouver

Maqbool M, Ali A, Ahmad MM, Mujeeb M, Ali MZ. Quantification and Health Assessment of Microfiber Contamination in Selected Textile Processing Units of Punjab, Pakistan. Pakistan Journal of Science. 2025;77(04):568-576. doi:10.57041/91sa3b28

BibTeX
@article{Maqbool2025,
  author = {Maqbool, Maham and Ali, Azhar and Ahmad, Malik Mansoor and Mujeeb, Maheen and Ali, Muhammad Zeeshan},
  title = {Quantification and Health Assessment of Microfiber Contamination in Selected Textile Processing Units of Punjab, Pakistan},
  journal = {Pakistan Journal of Science},
  year = {2025},
  volume = {77},
  number = {04},
  pages = {568--576},
  doi = {10.57041/91sa3b28}
}
Kostenlos starten →