EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Comparative Numerical Analysis Study of the Lateral Performance of Steel Shear Walls with Dual-Layer Infill Plates

Qiaoqiao ZHANG, Xiaosheng LIU

Electronic Journal of Structural Engineering · 01.07.2026 · 26 (2) · 88-96

DOI: 10.56748/ejse.26974 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Electronic Journal of Structural Engineering, online erschienen am 01.07.2026. Verfasst von Qiaoqiao ZHANG und 1 weiteren Autor:innen. Die Arbeit nennt 48 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Traditional steel shear walls (SSWs) with flat infill plates have been widely used in regions of high seismic hazard due to their high strength and energy dissipation capacity. However, premature buckling of flat plates reduces their structural performance, motivating the development of trapezoidal corrugated steel shear walls (CSSWs). To further address the limitations of single corrugated walls, double corrugated steel shear walls (DCSSWs) were introduced, followed by hybrid flat–corrugated steel shear walls (FCSSWs), which combine a flat plate with a trapezoidal corrugated plate. This study numerically investigates the lateral behavior of three SSW systems: single CSSWs, DCSSWs, and hybrid FCSSWs. Finite element models are developed using ABAQUS and analyzed under lateral loading. The effects of geometric parameters are examined by considering aspect ratios (L/h) ranging from 0.67 to 2 and corrugation angles of 30°, 45°, and 60°. The results indicate that dual-layer systems (DCSSW and FCSSW) significantly improve structural stability compared with single-layer CSSWs. Among the examined systems, the FCSSW exhibits the most stable nonlinear response, showing no strength degradation up to a 2% story drift. In contrast, the CSSW and the DCSSW with a 30° corrugation angle experience noticeable strength degradation. In terms of peak strength, the FCSSW consistently outperforms the CSSW, with the maximum increase (approximately 15.1%) observed at lower aspect ratios. The DCSSW achieves the highest ultimate strength, exceeding that of the FCSSW by 1.6–4.3% and the CSSW by 3.4–12.3%. Initial lateral stiffness is comparable among all systems, with only minor differences observed.

Zitieren

APA

ZHANG, Q., & LIU, X. (2026). Comparative Numerical Analysis Study of the Lateral Performance of Steel Shear Walls with Dual-Layer Infill Plates. Electronic Journal of Structural Engineering, 26(2), 88-96. https://doi.org/10.56748/ejse.26974

Vancouver

ZHANG Q, LIU X. Comparative Numerical Analysis Study of the Lateral Performance of Steel Shear Walls with Dual-Layer Infill Plates. Electronic Journal of Structural Engineering. 2026;26(2):88-96. doi:10.56748/ejse.26974

BibTeX
@article{ZHANG2026,
  author = {ZHANG, Qiaoqiao and LIU, Xiaosheng},
  title = {Comparative Numerical Analysis Study of the Lateral Performance of Steel Shear Walls with Dual-Layer Infill Plates},
  journal = {Electronic Journal of Structural Engineering},
  year = {2026},
  volume = {26},
  number = {2},
  pages = {88--96},
  doi = {10.56748/ejse.26974}
}
Kostenlos starten →