EUVIMEDEUVIMED entdecken
Crossref

Design and Manufacturing of a Pin on Disk Tribometer

Korcan Küçüköztaş, İlker Talay, Fatih Çalışkan, Mustafa Elsakka, Mohammed Nassar, Bilgin Kaftanoğlu

Makina Tasarım ve İmalat Dergisi · 2024

DOI: 10.56193/matim.1353203 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Makina Tasarım ve İmalat Dergisi, 2024. Verfasst von Korcan Küçüköztaş und 5 weiteren Autor:innen. Die Arbeit nennt 15 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents the design and manufacturing of a pin on disk tribometer aimed at performing friction and wear testing as accurate as a professional tribometer at a lower cost. Since friction is an important part of our lives and its application varies greatly in size, environment and other factors, testing can be expensive. Tribometers are instruments where these conditions can be simulated experimentally. They are manufactured by various companies abroad and are imported to Turkey. For this reason, the cost of these instruments is very high. The design of the proposed tribometer prioritizes portability and low cost of manufacturing. The manufacturing process of the various parts are discussed in detail. The tribometer was manufactured in the ATILIM University manufacturing laboratories within a tight budget using CNC machining. The instrument has the full capability to adjust the load, testing radius, motor speed, and the duration of the test before starting the experiments. To handle the electronics and data gathering within the instrument, Arduino boards and software are utilized. Real-time data streaming is made possible for data analysis tasks both during and after the experiments. The paper also provides the results of experiments that are obtained from the newly developed tribometer and comparisons with a mass produced, professional tribometer. The experiments are conducted with the same type of samples and with the same parameters. The proposed tribometer provides researchers with easily accessible friction data that is within close range to what they would get from a professional tribometer.

Zitieren

APA

Küçüköztaş, K., Talay, İ., Çalışkan, F., Elsakka, M., Nassar, M., & Kaftanoğlu, B. (2024). Design and Manufacturing of a Pin on Disk Tribometer. Makina Tasarım ve İmalat Dergisi. https://doi.org/10.56193/matim.1353203

Vancouver

Küçüköztaş K, Talay İ, Çalışkan F, Elsakka M, Nassar M, Kaftanoğlu B. Design and Manufacturing of a Pin on Disk Tribometer. Makina Tasarım ve İmalat Dergisi. 2024. doi:10.56193/matim.1353203

BibTeX
@article{Kkzta2024,
  author = {Küçüköztaş, Korcan and Talay, İlker and Çalışkan, Fatih and Elsakka, Mustafa and Nassar, Mohammed and Kaftanoğlu, Bilgin},
  title = {Design and Manufacturing of a Pin on Disk Tribometer},
  journal = {Makina Tasarım ve İmalat Dergisi},
  year = {2024},
  doi = {10.56193/matim.1353203}
}
Kostenlos starten →