Mechanical characterisation of glass and stress reduction in glass dome
Archives of Materials Science and Engineering · 01.03.2026
DOI: 10.5604/01.3001.0055.8032 ↗Kurz gefasst
Fachartikel in der Zeitschrift Archives of Materials Science and Engineering, erschienen am 01.03.2026. Verfasst von R. Tkach.
Abstract (Originalsprache)
The aim of the study is to investigate the influence of experimentally determined mechanical properties of glass on the stress–strain state of a thin-walled glass dome.
Experimental tests were conducted to determine the mechanical properties of glass. Twenty cubic (30 × 30 × 30 mm) and twenty prismatic (30 × 30 × 60 mm) specimens were tested under axial compression. The elastic modulus and Poisson’s ratio were obtained from strain-gauge measurements, and the results were statistically analysed using a two- and three-parameter Weibull distribution. The obtained parameters were used to perform finite element modelling of a glass dome in Siemens Simcenter Femap using NX Nastran.
The failure of glass specimens under compression is brittle and characterised by longitudinal cracking and local crushing in the contact zone with the press plates. The characteristic compressive strength was 213 MPa for cubes and 153 MPa for prisms. The elastic modulus of glass was determined as E = 6.55 × 1010 Pa and Poisson’s ratio as ν = 0.25. Numerical mod-elling showed that increasing the thickness of the local thickening at the dome apex from 6 to 7 mm reduces the maximum stresses by approximately 20%.
The results are based on experimental studies of specimens with limited dimensions and on numerical modelling of a sin-gle dome-shell geometry.
The results obtained can be used in the design of glass shell structures and in the refinement of numerical models of their stress–strain state.
The scientific novelty of this study lies in combining experimental determination of the mechanical properties of glass with Weibull statistical analysis and the subsequent application of the resulting parameters to finite element modelling of a glass dome.
Zitieren
APA
Tkach, R. (2026). Mechanical characterisation of glass and stress reduction in glass dome. Archives of Materials Science and Engineering. https://doi.org/10.5604/01.3001.0055.8032
Vancouver
Tkach R. Mechanical characterisation of glass and stress reduction in glass dome. Archives of Materials Science and Engineering. 2026. doi:10.5604/01.3001.0055.8032
BibTeX
@article{Tkach2026,
author = {Tkach, R.},
title = {Mechanical characterisation of glass and stress reduction in glass dome},
journal = {Archives of Materials Science and Engineering},
year = {2026},
doi = {10.5604/01.3001.0055.8032}
}
EUVIMED