Fabrication of humidity-sensitive biocomposite smart material by using an FGF process
Archives of Materials Science and Engineering · 01.02.2026
DOI: 10.5604/01.3001.0055.7858 ↗Kurz gefasst
Fachartikel in der Zeitschrift Archives of Materials Science and Engineering, erschienen am 01.02.2026. Verfasst von B. Al Nahari und 4 weiteren Autor:innen. Die Arbeit nennt 27 Literaturangaben.
Abstract (Originalsprache)
The research focuses on the possibility of using the cellulose fibre (C6H10O5)n - that is prepared from sugarcane bagasse - to produce a biocomposite that can be used as a humidity-responsive smart material by using an FGF printer and finding out the limitations, the challenges, and the alternatives to enhance this process.
We prepared a biocomposite smart material by reinforcing recycled polylactic acid (rPLA) with cellulose fibres (CF) produced from sugarcane bagasse waste, as well as cellulose HM30, industrially fabricated. We printed the samples (ISO 527-2 5A) using an FGF printer and studied the mechanical properties using tensile tests, whereas moisture sensitivity was assessed by water absorption and dimensional accuracy analysis via immersion in distilled water.
We found that the specimen reinforced with 1% CF exhibits enhanced strength and stiffness through improved crystallinity and densification, albeit at the expense of reduced ductility. Water absorption increased constantly with CF doped content, from ~1.7% in rPLA-CF1% to ~4.4% in 15%HM30-rPLA after 216 hours, along with small dimensional swelling. The results validate the typical and adjustable humidity response of these biocomposites.
We were encountering an issue with printing using high percentages of CF that caused clogging in the nozzle of the FGF printer, and that happened because of the CF high density. We test another type of cellulose fibres, HM-30 (industrially fabricated), which have a low density. We successfully ran a test print at a high CF ratio used in the first tests, without any issues.
The study confirms the fabrication of rPLA-CF biocomposite smart material by using an FGF process to print humidity-sensitive smart material that will be used in 4D printing and its applications.
Zitieren
APA
Nahari, B. A., Zarbane, K., Beidouri, Z., Elhalil, A., & Kissi, B. (2026). Fabrication of humidity-sensitive biocomposite smart material by using an FGF process. Archives of Materials Science and Engineering. https://doi.org/10.5604/01.3001.0055.7858
Vancouver
Nahari BA, Zarbane K, Beidouri Z, Elhalil A, Kissi B. Fabrication of humidity-sensitive biocomposite smart material by using an FGF process. Archives of Materials Science and Engineering. 2026. doi:10.5604/01.3001.0055.7858
BibTeX
@article{Nahari2026,
author = {Nahari, B. Al and Zarbane, K. and Beidouri, Z. and Elhalil, A. and Kissi, B.},
title = {Fabrication of humidity-sensitive biocomposite smart material by using an FGF process},
journal = {Archives of Materials Science and Engineering},
year = {2026},
doi = {10.5604/01.3001.0055.7858}
}
EUVIMED