EUVIMEDEUVIMED entdecken
Crossref

Surface plastic deformation of leaded brass components using a Ferro-Tic Grade C cylindrical-ended deforming element

M. Ichkova, K. Anastasov, T. Dikova

Archives of Materials Science and Engineering · 01.09.2025

DOI: 10.5604/01.3001.0055.6368 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Archives of Materials Science and Engineering, erschienen am 01.09.2025. Verfasst von M. Ichkova und 2 weiteren Autor:innen. Die Arbeit nennt 57 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

To disclose the capabilities of slide burnishing (SB) conducted using a cylindrical-ended, non-diamond-based deforming element to improve the roughness of CuZn39Pb3 alloy components.A full factorial experiment, analysis of variance, regression analysis, and an optimisation procedure based on the NSGA II algorithm were employed.The Ferro-Tic Grade C hard alloy can be successfully used to produce deforming elements in burnishing processes, when the processed material is a copper-based alloy. Under conditions of tangential sliding friction contact between the deforming element and the processed surface, no negative effects due to adhesion were observed.The research answered some questions about improving the roughness of CuZn39Pb3 alloy components, but also revealed the need for future research on the SB of this alloy using Ferro-Tic Grade C hard-alloy deforming elements.The optimal values of the governing factors (radius of 5 mm, burnishing force of 207 N, feed rate of 0.089 mm/rev, and burnishing velocity of 70 m/min) yielded a minimum value of the Ra roughness parameter of 0.139 μm. Understanding the correlation between roughness and operating behaviour can significantly improve the fatigue, tribological, and corrosion behaviour of such a component.The literature lacks information on the effects of surface plastic deformation on the surface integrity (SI) of the alloy. There is also a lack of information on the technological capabilities of the hard alloy Ferro-Tic Grade C used as a deforming element in the burnishing process. The study partially fills this gap by shedding light on the effect of SB on the roughness.

Zitieren

APA

Ichkova, M., Anastasov, K., & Dikova, T. (2025). Surface plastic deformation of leaded brass components using a Ferro-Tic Grade C cylindrical-ended deforming element. Archives of Materials Science and Engineering. https://doi.org/10.5604/01.3001.0055.6368

Vancouver

Ichkova M, Anastasov K, Dikova T. Surface plastic deformation of leaded brass components using a Ferro-Tic Grade C cylindrical-ended deforming element. Archives of Materials Science and Engineering. 2025. doi:10.5604/01.3001.0055.6368

BibTeX
@article{Ichkova2025,
  author = {Ichkova, M. and Anastasov, K. and Dikova, T.},
  title = {Surface plastic deformation of leaded brass components using a Ferro-Tic Grade C cylindrical-ended deforming element},
  journal = {Archives of Materials Science and Engineering},
  year = {2025},
  doi = {10.5604/01.3001.0055.6368}
}
Kostenlos starten →