EUVIMEDEUVIMED entdecken
Crossref

Determination of the anisotropy level of mechanical properties of sheets unrolled from coils made of selected steel grades

Grzegorz Stradomski, Sebastian Mroz, Piotr Szota, Tomasz Garstka, Jakub Gróbarczyk, Radosław Gryczkowski

Journal of Engineering 360 · 2025

DOI: 10.5604/01.3001.0055.3329 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Engineering 360, 2025. Verfasst von Grzegorz Stradomski und 5 weiteren Autor:innen. Die Arbeit nennt 16 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents an analysis of the anisotropy of mechanical properties of the investigated sheets based on the results of static tensile testing and HV hardness measurements. The objective of the study was to evaluate variations in mechanical properties in three key areas along the coil length. In addition, an analysis across the sheet width was performed. It was found, among other things, that there are clear differences in hardness between the beginning, middle, and end areas of the coil. The differences in hardness ranged from approximately 2.3 to as much as 12.9 units, with higher values observed for hot-rolled sheets. Differences in hardness between the edge and the center of the sheet were also observed in all three zones. The largest differences in yield strength and tensile strength values, regardless of steel grade, were obtained across the sheet width at the beginning or end of the coil. Based on the analysis of the obtained results, the level of anisotropy of the mechanical properties of the sheets was determined for the individual dimensions and steel grades. The results demonstrated that anisotropy is more pronounced across the sheet width than along the coil length. It was also shown that hot-rolled sheets exhibit higher anisotropy compared to cold-rolled sheets. The obtained results provided the basis for developing an innovative tension-straightening technology for sheets uncoiled from coils and formed into flat sheets.

Zitieren

APA

Stradomski, G., Mroz, S., Szota, P., Garstka, T., Gróbarczyk, J., & Gryczkowski, R. (2025). Determination of the anisotropy level of mechanical properties of sheets unrolled from coils made of selected steel grades. Journal of Engineering 360. https://doi.org/10.5604/01.3001.0055.3329

Vancouver

Stradomski G, Mroz S, Szota P, Garstka T, Gróbarczyk J, Gryczkowski R. Determination of the anisotropy level of mechanical properties of sheets unrolled from coils made of selected steel grades. Journal of Engineering 360. 2025. doi:10.5604/01.3001.0055.3329

BibTeX
@article{Stradomski2025,
  author = {Stradomski, Grzegorz and Mroz, Sebastian and Szota, Piotr and Garstka, Tomasz and Gróbarczyk, Jakub and Gryczkowski, Radosław},
  title = {Determination of the anisotropy level of mechanical properties of sheets unrolled from coils made of selected steel grades},
  journal = {Journal of Engineering 360},
  year = {2025},
  doi = {10.5604/01.3001.0055.3329}
}
Kostenlos starten →