EUVIMEDEUVIMED entdecken
Crossref

Additive concentration and nozzle moving speed influence on local copper deposition for electrochemical 3D-printing

Roman Babchuk, Dmytro Uschapovskiy, Viktoria Vorobyova, Olga Linyucheva, Mykhailo Kotyk, Georgii Vasyliev

Journal of Electrochemical Science and Engineering · 25.03.2024

DOI: 10.5599/jese.2291 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Electrochemical Science and Engineering, online erschienen am 25.03.2024. Verfasst von Roman Babchuk und 5 weiteren Autor:innen. Die Arbeit wurde bisher 5-mal zitiert (Crossref). Gefördert von: Ministry of Education and Science of Ukraine.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The local deposition process from copper sulfate electrolyte was investigated depending on nozzle moving speed and additive concentration in the electrolyte. A 2×2 cm square model was created and sliced in Ultimaker Cura software, uploaded in a 3D printer, and printed from the copper electrolyte on the stainless-steel surface. Low additive concentration in the electrolyte was found to influence dendrite formation in the corner sections of a square model. Nozzle movement speed was found to influence the deposition area and the thickness of the metal. The lowest tested nozzle movement speed of 5 s / voxel increased the deposition area by nearly 40 % in horizontal direction compared to 2.5 s / voxel. Further increase of nozzle movement speed to 1.6 s / voxel does not change the deposition area. The thickness in the corners increases by 2.5 times compared to the straight section of the square when the nozzle movement speed increases from 5 to 1.6 s / voxel. The non-uniform thickness of the deposited metal is caused by a considerable reduction of nozzle movement speed when it moves through the corner. The results obtained in this work can be further used to develop electrochemical 3D printing technology.

Förderung

  • Ministry of Education and Science of Ukraine

Zitieren

APA

Babchuk, R., Uschapovskiy, D., Vorobyova, V., Linyucheva, O., Kotyk, M., & Vasyliev, G. (2024). Additive concentration and nozzle moving speed influence on local copper deposition for electrochemical 3D-printing. Journal of Electrochemical Science and Engineering. https://doi.org/10.5599/jese.2291

Vancouver

Babchuk R, Uschapovskiy D, Vorobyova V, Linyucheva O, Kotyk M, Vasyliev G. Additive concentration and nozzle moving speed influence on local copper deposition for electrochemical 3D-printing. Journal of Electrochemical Science and Engineering. 2024. doi:10.5599/jese.2291

BibTeX
@article{Babchuk2024,
  author = {Babchuk, Roman and Uschapovskiy, Dmytro and Vorobyova, Viktoria and Linyucheva, Olga and Kotyk, Mykhailo and Vasyliev, Georgii},
  title = {Additive concentration and nozzle moving speed influence on local copper deposition for electrochemical 3D-printing},
  journal = {Journal of Electrochemical Science and Engineering},
  year = {2024},
  doi = {10.5599/jese.2291}
}
Kostenlos starten →