EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Investigation of thermoelectric characteristics of MoS2 in bulk and thin film structures

Melania Suweni Muntini, Irasani Rahayu, Mekhala Insawang, Widya Dewayanti P, Surasak Ruamruk, Somporn Thaowankaew, Iim Fatimah, Tosawat Seetawan, Athorn Voraud

Creative Science · 10.03.2026 · 18 (2) · 266048

DOI: 10.55674/cs.v18i2.266048 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Creative Science, online erschienen am 10.03.2026. Verfasst von Melania Suweni Muntini und 8 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this work, we investigated and compared the thermoelectric properties of molybdenum disulfide (MoS2) in bulk and thin-film structures. The bulk MoS2 was synthesized by hot pressing (HP) at 700°C from MoS2 nano-powder. While MoS2 thin film was fabricated via radio-frequency (RF) magnetron sputtering at ambient temperature using a MoS2 bulk target and then annealed at 700oC. After bulk and thin-film MoS2 samples were prepared, the characterization of crystal structure, surface morphology, and atomic composition was performed using X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy-dispersive X-ray spectroscopy (EDX), respectively. The electrical resistivity (ρ) and Seebeck coefficient (S) were measured by the ZEM-3 method to determine the thermoelectric power factor (PF). The results revealed that bulk MoS2 exhibited p-type thermoelectricity. In contrast, the MoS2 thin films exhibited n-type thermoelectricity. Among the thermoelectric power factors, the highest power factor of bulk MoS2 was 0.52 mW m⁻¹ K⁻², while the highest power factor of thin film MoS2 was 3.14 mW m⁻¹ K⁻² at the temperature measurement 473K. GRAPHICAL ABSTRACT HIGHLIGHTS • The microstructure of MoS₂ has differed due to three-dimensional (bulk) and two-dimensional (thin film) to show the hexagonal phase for bulk and 2H for thin film.• The microstructure of MoS₂ has induced a p-type thermoelectricity on bulk structure and transferred to an n-type thermoelectricity on thin film structure.• The power factor of MoS₂ thin films was higher than that of bulk MoS₂, indicating superior electrical energy conversion efficiency in the thin-film structure.

Zitieren

APA

Muntini, M. S., Rahayu, I., Insawang, M., P, W. D., Ruamruk, S., Thaowankaew, S., Fatimah, I., Seetawan, T., & Voraud, A. (2026). Investigation of thermoelectric characteristics of MoS2 in bulk and thin film structures. Creative Science, 18(2), 266048. https://doi.org/10.55674/cs.v18i2.266048

Vancouver

Muntini MS, Rahayu I, Insawang M, P WD, Ruamruk S, Thaowankaew S, et al. Investigation of thermoelectric characteristics of MoS2 in bulk and thin film structures. Creative Science. 2026;18(2):266048. doi:10.55674/cs.v18i2.266048

BibTeX
@article{Muntini2026,
  author = {Muntini, Melania Suweni and Rahayu, Irasani and Insawang, Mekhala and P, Widya Dewayanti and Ruamruk, Surasak and Thaowankaew, Somporn and Fatimah, Iim and Seetawan, Tosawat and Voraud, Athorn},
  title = {Investigation of thermoelectric characteristics of MoS2 in bulk and thin film structures},
  journal = {Creative Science},
  year = {2026},
  volume = {18},
  number = {2},
  pages = {266048},
  doi = {10.55674/cs.v18i2.266048}
}
Kostenlos starten →