Numerical Analysis and Optimization of Hydroforming Parameters of a 2024-T3 Aluminum Alloy Interface Part for Aerospace Applications
The Eurasia Proceedings of Science, Technology, Engineering and Mathematics · 31.07.2026 · 40 ((Early Pub)) · 330-340
DOI: 10.55549/epstem.1457 ↗Kurz gefasst
Fachartikel in der Zeitschrift The Eurasia Proceedings of Science, Technology, Engineering and Mathematics, online erschienen am 31.07.2026. Verfasst von Caner Ture und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This study investigates the production of a 2024-T3 aluminum alloy interface component, designed for the mounting of a commercial antenna onto a helicopter tail, using the hydroforming process. Hydroforming is a widely utilized sheet metal forming technique in aerospace applications, operating on the principle of utilizing high fluid pressure to induce plastic deformation of the blank into a male or female die. Compared to conventional forming methods, it enables the production of complex geometries with superior quality. Within the scope of this work, the interface part was first designed to conform to the surfaces of both the antenna and the helicopter tail, followed by the development of the female hydroforming die geometry. The effects of critical process parameters, such as fluid pressure, blank holder force (BHF), and initial blank dimensions, on thinning and stress distribution were examined through Finite Element Analysis (FEA) based on the Forming Limit Diagram (FLD) and material hardening criteria. Through iterative simulations, the optimal process parameters required to prevent potential failure modes, such as tearing and wrinkling, were identified. The results indicate that fluid pressures reaching 50 MPa are necessary for successful forming, with a minimum achievable corner radius of 22 mm. Consequently, it is demonstrated that 2024-T3 alloy can be effectively formed into complex aerospace components using the hydroforming method.
Zitieren
APA
Ture, C., Katirci, B., & Turkoz, M. (2026). Numerical Analysis and Optimization of Hydroforming Parameters of a 2024-T3 Aluminum Alloy Interface Part for Aerospace Applications. The Eurasia Proceedings of Science, Technology, Engineering and Mathematics, 40((Early Pub)), 330-340. https://doi.org/10.55549/epstem.1457
Vancouver
Ture C, Katirci B, Turkoz M. Numerical Analysis and Optimization of Hydroforming Parameters of a 2024-T3 Aluminum Alloy Interface Part for Aerospace Applications. The Eurasia Proceedings of Science, Technology, Engineering and Mathematics. 2026;40((Early Pub)):330-340. doi:10.55549/epstem.1457
BibTeX
@article{Ture2026,
author = {Ture, Caner and Katirci, Batuhan and Turkoz, Mevlut},
title = {Numerical Analysis and Optimization of Hydroforming Parameters of a 2024-T3 Aluminum Alloy Interface Part for Aerospace Applications},
journal = {The Eurasia Proceedings of Science, Technology, Engineering and Mathematics},
year = {2026},
volume = {40},
number = {(Early Pub)},
pages = {330--340},
doi = {10.55549/epstem.1457}
}
EUVIMED