EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Exploring the Potentials of Calcined Clay as A Partial Clinker Substitute for the Environmental Sustainability of Cement: A Case Study of Foreke Dschang Clays, West Cameroon

Tassongwa Bernard, Anyam Talam Blaise, Tene Fongang Brice, Mfembena Pouepene Rosalie Arlette, Nkoumbou Charles

Earth Science Research · 28.03.2026 · 15 (1) · 36

DOI: 10.5539/esr.v15n1p36 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Earth Science Research, online erschienen am 28.03.2026. Verfasst von Tassongwa Bernard und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The aim of this study was to experimentally investigate the feasibility of using calcined clay as partial clinker substitute for sustainable cement manufacturing without compromising the performance of the cement. Clay sample were collected from Foreke Dschang. This clay underwent chemical analysis before and after calcination at 750 °C. For this calcined clay, the loss on ignition is negligible, its Σ(SiO2+Al2O3 +Fe2O3) ˃ 70 %, amorphous phase is present. These properties allow this calcined clay to be classified as a supplementary cementitious material (SCM). The cement samples were prepared by substituting 10%, 20%, 30%, and 40% of clinker with calcined clay (respectively CEM A, CEM B, CEM C and CEM D), and were tested in comparison to two control formulations substituting clinker at 17% and 25% with volcanic ash (LION and EXTRA respectively). The increase in the calcined clay content resulted in an increase in the water/cement ratio and the initial setting time. CEM A, CEM B and CEM C displayed good compressive strength, comparable to LION (42.5R) and EXTRA (32.5R) respectively. Furthermore, in comparison with LION cement, CEM B shows an increase in compressive strength of 12.6% and 2.55% at 2 and 28 days respectively, despite a 3% clinker deficiency. Also, in comparison with EXTRA cement, CEM C shows an increase in compressive strength of 12.14% and 3.51% at 2 and 28 days respectively, despite a 5% clinker deficiency. This reduction of 3 to 5 % clinker consumption reduced the carbon footprint of the cement industry.

Zitieren

APA

Bernard, T., Blaise, A. T., Brice, T. F., Arlette, M. P. R., & Charles, N. (2026). Exploring the Potentials of Calcined Clay as A Partial Clinker Substitute for the Environmental Sustainability of Cement: A Case Study of Foreke Dschang Clays, West Cameroon. Earth Science Research, 15(1), 36. https://doi.org/10.5539/esr.v15n1p36

Vancouver

Bernard T, Blaise AT, Brice TF, Arlette MPR, Charles N. Exploring the Potentials of Calcined Clay as A Partial Clinker Substitute for the Environmental Sustainability of Cement: A Case Study of Foreke Dschang Clays, West Cameroon. Earth Science Research. 2026;15(1):36. doi:10.5539/esr.v15n1p36

BibTeX
@article{Bernard2026,
  author = {Bernard, Tassongwa and Blaise, Anyam Talam and Brice, Tene Fongang and Arlette, Mfembena Pouepene Rosalie and Charles, Nkoumbou},
  title = {Exploring the Potentials of Calcined Clay as A Partial Clinker Substitute for the Environmental Sustainability of Cement: A Case Study of Foreke Dschang Clays, West Cameroon},
  journal = {Earth Science Research},
  year = {2026},
  volume = {15},
  number = {1},
  pages = {36},
  doi = {10.5539/esr.v15n1p36}
}
Kostenlos starten →