EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Effect of in series and in parallel flow heater configuration of solar heat system for industrial processes

Rajab Ghabour, Péter Korzenszky

Science, Technology and Innovation · 2021

DOI: 10.55225/sti.315 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Science, Technology and Innovation, 2021. Verfasst von Rajab Ghabour und 1 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The boiler is an enclosed vessel that transfers the energy from fuel combustion or electricity into hot water or steam. Then, this hot water or pressurized steam is used for transferring the heat to a certain heat process. Usually, the required hot water or steam keeps on varying throughout the day which also may be implied on the daily or monthly load. Therefore, several configurations of connecting the boiler into the solar heating system ensure the temperature of the final output. The boiler can be connected in series or parallel to improve the efficiency of the overall process as well as to reduce the running costs. This paper presents a simulation study of a solar heating system for industrial processes. Two flow-heater system configurations are designed for covering the heat demand of a pasteurising factory existing in Budapest, Hungary. The configuration “A” consists of a solar heating system for hot water preparation using in series flow heater configuration. While configuration “B” consists of the same solar system but with a parallel flow heater configuration. These system configurations are modelled using T*sol software for evaluating the system performance under the Hungarian climate from five different aspects: required collector area, glycol ratio, volume flow rate, relative tank capacity, and tank height-to-diameter ratio. According to the optimum design parameters, in series configuration is better than parallel by 3.14% at 45 m² collector area, 0.45% at 25% glycol ratio, 0.42% at 50 l/h · m² volume flow rate, 2.05% at 50 l/m² relative tank capacity, and 0.42% at 1.8 tank height-to-diameter ratio respectively. The results show that in series configuration is better in terms of solar fractions than parallel configuration from all five aspects.

Zitieren

APA

Ghabour, R., & Korzenszky, P. (2021). Effect of in series and in parallel flow heater configuration of solar heat system for industrial processes. Science, Technology and Innovation. https://doi.org/10.55225/sti.315

Vancouver

Ghabour R, Korzenszky P. Effect of in series and in parallel flow heater configuration of solar heat system for industrial processes. Science, Technology and Innovation. 2021. doi:10.55225/sti.315

BibTeX
@article{Ghabour2021,
  author = {Ghabour, Rajab and Korzenszky, Péter},
  title = {Effect of in series and in parallel flow heater configuration of solar heat system for industrial processes},
  journal = {Science, Technology and Innovation},
  year = {2021},
  doi = {10.55225/sti.315}
}
Kostenlos starten →