Effect of Filling Ratio on Mechanical, Density and Surface Wetting Properties of Si6.5Fe/HDPE Composites
Frontiers in Science and Engineering · 19.11.2026 · 6 (11) · 32-38
DOI: 10.54691/ahhn1e43 ↗Kurz gefasst
Fachartikel in der Zeitschrift Frontiers in Science and Engineering, online erschienen am 19.11.2026. Verfasst von Jingyue Zhang. Die Arbeit nennt 7 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0).
Abstract (Originalsprache)
To meet the demands of corrosion resistance, light weight, certain load-bearing capacity and ballast for PE-boat applications, high-density polyethylene (HDPE, Formosa 9001, extrusion grade) was used as the continuous phase and Si6.5Fe Fe-Si alloy powder as the functional filler. Under a fixed baseline hot-pressing process (200 °C, holding pressure for 15 min, 10–15 MPa, staged venting), five composites with powder-to-HDPE mass ratios of 2:8, 3:7, 4:6, 5:5 and 6:4 were prepared, and their tensile yield and fracture performance, density, water contact angle and Izod notched impact strength were tested. Results show that as the filling ratio increases, the mean yield strength decreases from 23.38 MPa to 18.68 MPa, the actual fracture force from 789.76 N to 694.96 N, density rises monotonically from 1.13 g/cm³ to 1.95 g/cm³, the contact angle rises from 67.21° to a peak of 75.57° at 5:5 and then falls back to 74.54°, and the Izod notched impact strength decreases from 10.98 kJ/m² to 7.20 kJ/m². All five ratios exceed the 17 MPa yield-strength threshold, and the measured density agrees closely with the rule-of-mixtures value, indicating good compactness. The study provides an experimental basis for selecting the optimal filling ratio and for subsequent hot-pressing process optimization.
Zitieren
APA
Zhang, J. (2026). Effect of Filling Ratio on Mechanical, Density and Surface Wetting Properties of Si6.5Fe/HDPE Composites. Frontiers in Science and Engineering, 6(11), 32-38. https://doi.org/10.54691/ahhn1e43
Vancouver
Zhang J. Effect of Filling Ratio on Mechanical, Density and Surface Wetting Properties of Si6.5Fe/HDPE Composites. Frontiers in Science and Engineering. 2026;6(11):32-38. doi:10.54691/ahhn1e43
BibTeX
@article{Zhang2026,
author = {Zhang, Jingyue},
title = {Effect of Filling Ratio on Mechanical, Density and Surface Wetting Properties of Si6.5Fe/HDPE Composites},
journal = {Frontiers in Science and Engineering},
year = {2026},
volume = {6},
number = {11},
pages = {32--38},
doi = {10.54691/ahhn1e43}
}
EUVIMED