Experimental investigation on mechanical properties of post-weld heat-treated Inconel 718/316L dissimilar TIG weldments
Arashi Journal of Metals & Material Sciences · 2025 · 2 (1) · 30-34
DOI: 10.54646/jmms.2025.0004 ↗Kurz gefasst
Fachartikel in der Zeitschrift Arashi Journal of Metals & Material Sciences, 2025. Verfasst von B. K. Parrthipan und 5 weiteren Autor:innen.
Abstract (Originalsprache)
Dissimilar welding of nickel-based superalloys with austenitic stainless steels is crucial for the development of advanced engineering systems operating under extreme temperature and mechanical load conditions. This study reports the welding of Inconel 718 to AISI 316L stainless steel by means of continuous current Tungsten Inert Gas (TIG) welding and ERNiCrMo-4 as the filler metal. The influence of post-weld heat treatment (PWHT) on the mechanical properties of the joint has been investigated. PWHT was conducted by heating the samples to 450◦C, 650◦C, and 850◦C for 2 h in a controlled furnace and then cooling them in the air. We examined the microhardness changes in the base metal, heat-affected zone, and fusion zone (FZ), and also the tensile properties at room temperature according to ASTM standards. The welded joint had a peak FZ hardness of nearly 220 HV and a very low ductility of 9.6%. The FZ was about 23% harder due to the strengthening of Inconel 718 by precipitation after PWHT at 650◦C, but softening occurred at 850◦C due to over-aging and coarser phases. Although the ductility dropped as a result of the above, the material after PWHT at 850◦C exhibited the highest tensile strength (416 MPa) and elongation (37.8%), which are more than 300% higher than the welded state.
Zitieren
APA
Parrthipan, B. K., Narayanasamy, P., Balavariavan, B., Sahi, D. V., Aathi, V., & Przestacki, D. (2025). Experimental investigation on mechanical properties of post-weld heat-treated Inconel 718/316L dissimilar TIG weldments. Arashi Journal of Metals & Material Sciences, 2(1), 30-34. https://doi.org/10.54646/jmms.2025.0004
Vancouver
Parrthipan BK, Narayanasamy P, Balavariavan B, Sahi DV, Aathi V, Przestacki D. Experimental investigation on mechanical properties of post-weld heat-treated Inconel 718/316L dissimilar TIG weldments. Arashi Journal of Metals & Material Sciences. 2025;2(1):30-34. doi:10.54646/jmms.2025.0004
BibTeX
@article{Parrthipan2025,
author = {Parrthipan, B. K. and Narayanasamy, P. and Balavariavan, B. and Sahi, D. V. and Aathi, V. and Przestacki, Damian},
title = {Experimental investigation on mechanical properties of post-weld heat-treated Inconel 718/316L dissimilar TIG weldments},
journal = {Arashi Journal of Metals & Material Sciences},
year = {2025},
volume = {2},
number = {1},
pages = {30--34},
doi = {10.54646/jmms.2025.0004}
}
EUVIMED