EUVIMEDEUVIMED entdecken
Crossref

Development of a low-cost laparotomy and fascial closure simulator

Victor Moas, Christopher Dyke, Steven Kurapaty, Spencer Vandecar, Peter Liacouras, Jason Souza, E. Matthew Ritter, Brenton Franklin, William B. Sweeney

Journal of Healthcare Simulation · 06.04.2026

DOI: 10.54531/kvgu3262 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Healthcare Simulation, online erschienen am 06.04.2026. Verfasst von Victor Moas und 8 weiteren Autor:innen. Die Arbeit nennt 22 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Introduction

The ability to gain access to the peritoneal cavity and perform dependable fascial and skin closure is foundational in surgical training. We developed and evaluated a realistic, low-cost synthetic abdominal wall simulator incorporating a biomechanically similar fascial layer.

Methods

We iteratively engineered a layered abdominal wall model in an 18 × 18 cm frame using pigmented silicone elastomers and a nylon/spandex power mesh to emulate fascia, muscle, adipose tissue and skin. Ten practising surgeons at a US academic military hospital performed a midline laparotomy and closure on the device and then rated realism (palpation, incision, grasping, suturing, stapling) and the model’s acceptability for training. Cost and build time (including cure intervals) were recorded.

Results

Tooling cost for the reusable mould and rectus frame was approximately $125, with $34.38 in materials per additional unit. Using two frames, manufacture time was ~21 hours, driven by cure times across layers. After use, nine out of ten surgeons rated palpation, incision and suturing as somewhat similar or similar to living tissue; six out of ten rated grasping as somewhat similar or similar; eight out of ten rated skin stapling as somewhat similar or similar; ten out of ten judged the simulator acceptable for teaching midline laparotomy; and nine out of ten judged it acceptable for teaching fascial closure.

Discussion

Our construct provides a reproducible, inexpensive simulator for teaching laparotomy creation and closure using widely available materials. Surgeon ratings support acceptable face realism and broad training utility, with grasping fidelity identified as a target for refinement. Future work should incorporate trainee perspectives, multi-institutional testing and iterative material adjustments to optimize handling characteristics.

Zitieren

APA

Moas, V., Dyke, C., Kurapaty, S., Vandecar, S., Liacouras, P., Souza, J., Ritter, E. M., Franklin, B., & Sweeney, W. B. (2026). Development of a low-cost laparotomy and fascial closure simulator. Journal of Healthcare Simulation. https://doi.org/10.54531/kvgu3262

Vancouver

Moas V, Dyke C, Kurapaty S, Vandecar S, Liacouras P, Souza J, et al. Development of a low-cost laparotomy and fascial closure simulator. Journal of Healthcare Simulation. 2026. doi:10.54531/kvgu3262

BibTeX
@article{Moas2026,
  author = {Moas, Victor and Dyke, Christopher and Kurapaty, Steven and Vandecar, Spencer and Liacouras, Peter and Souza, Jason and Ritter, E. Matthew and Franklin, Brenton and Sweeney, William B.},
  title = {Development of a low-cost laparotomy and fascial closure simulator},
  journal = {Journal of Healthcare Simulation},
  year = {2026},
  doi = {10.54531/kvgu3262}
}
Kostenlos starten →