EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Modelling and simulation of flexural behavior for reinforced concrete beams using ANSYS

Mohamed Khalifa Bneni, Samir Hasuna Ashour

Al-Mukhtar Journal of Engineering Research · 2024

DOI: 10.54172/mx8n6k70 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Al-Mukhtar Journal of Engineering Research, 2024. Verfasst von Mohamed Khalifa Bneni und 1 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Over the last twenty years, many investigators are used finite element software, to validate and compare the FE results with their experimental research. This work focused on the development of a numerical model implemented by the ANSYS 2022R2 software, to simulate the flexural behavior of the RC beam. Numerical models are tested under four-point bending. To investigate the influence of reinforcement steel ratio and compressive strength of concrete on the flexural capacity of the model. The results indicated that the Finite Element model was able to predict the flexural behavior of the experimental test beam. Furthermore, the influence of different tensile reinforcement ratios has the most effect on the flexural behaviour of the FE models at maximum loads. While the change in concrete compressive strength has affected the flexural performance of the models. This influence shows slight increases in the first crack load and maximum loads of the models. Furthermore, cracking pattern behaviour at the final stage for numerical models showed a good agreement with experimental cracks behaviour.

Zitieren

APA

Bneni, M. K., & Ashour, S. H. (2024). Modelling and simulation of flexural behavior for reinforced concrete beams using ANSYS. Al-Mukhtar Journal of Engineering Research. https://doi.org/10.54172/mx8n6k70

Vancouver

Bneni MK, Ashour SH. Modelling and simulation of flexural behavior for reinforced concrete beams using ANSYS. Al-Mukhtar Journal of Engineering Research. 2024. doi:10.54172/mx8n6k70

BibTeX
@article{Bneni2024,
  author = {Bneni, Mohamed Khalifa and Ashour, Samir Hasuna},
  title = {Modelling and simulation of flexural behavior for reinforced concrete beams using ANSYS},
  journal = {Al-Mukhtar Journal of Engineering Research},
  year = {2024},
  doi = {10.54172/mx8n6k70}
}
Kostenlos starten →