EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Experimental Evaluation of a Hold-State Fuzzy Supervisor for P&O–PSO MPPT in an ESP8266-Based Standalone Photovoltaic System

Olusesan Orebanjo, Ikenna Augustine Onyegbadue, Dedacus N. Ohaegbuchi, Abiebhode Fred Izilein

IPS Journal of Engineering and Technology · 08.11.2026 · 2 (2) · 261-276

DOI: 10.54117/1dxqck90 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IPS Journal of Engineering and Technology, online erschienen am 08.11.2026. Verfasst von Olusesan Orebanjo und 3 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Rapid irradiance variation exposes a practical trade-off in photovoltaic maximum power point tracking (MPPT): perturb-and-observe (P&O) is inexpensive to execute but oscillates around the maximum power point, whereas particle swarm optimization (PSO) can recover the optimum after large operating changes but requires more computation. This paper develops a hold-state fuzzy supervisor that assigns duty-cycle calculation to either P&O or PSO according to the normalized power error and its change. Fuzzy logic is therefore used only for mode selection; it does not act as a third MPPT algorithm or directly generate the pulse-width-modulation duty cycle. When the operating point enters a prescribed convergence region, the controller retains the last accepted duty cycle until the measured error indicates a material change. The method was first evaluated in MATLAB/Simulink and then implemented on an ESP8266-based 50 W standalone PV prototype subjected to the same 25 s stepped-irradiance profile. Under the reported test conditions, the supervisor achieved a convergence time of 0.12 s, a settling time of 0.16 s, a tracking efficiency of 99.78%, a steady-state power ripple of 0.48%, and a peak overshoot of 0.82%. The corresponding values for P&O were 0.35 s, 0.42 s, 98.95%, 1.82%, and 2.60%, while PSO achieved 0.18 s, 0.24 s, 99.42%, 0.91%, and 1.35% respectively. The results indicate that separating supervisory selection from duty-cycle generation can improve dynamic tracking and steady-state stability while retaining suitability for low-cost embedded hardware.

Zitieren

APA

Orebanjo, O., Onyegbadue, I. A., Ohaegbuchi, D. N., & Izilein, A. F. (2026). Experimental Evaluation of a Hold-State Fuzzy Supervisor for P&O–PSO MPPT in an ESP8266-Based Standalone Photovoltaic System. IPS Journal of Engineering and Technology, 2(2), 261-276. https://doi.org/10.54117/1dxqck90

Vancouver

Orebanjo O, Onyegbadue IA, Ohaegbuchi DN, Izilein AF. Experimental Evaluation of a Hold-State Fuzzy Supervisor for P&O–PSO MPPT in an ESP8266-Based Standalone Photovoltaic System. IPS Journal of Engineering and Technology. 2026;2(2):261-276. doi:10.54117/1dxqck90

BibTeX
@article{Orebanjo2026,
  author = {Orebanjo, Olusesan and Onyegbadue, Ikenna Augustine and Ohaegbuchi, Dedacus N. and Izilein, Abiebhode Fred},
  title = {Experimental Evaluation of a Hold-State Fuzzy Supervisor for P&O–PSO MPPT in an ESP8266-Based Standalone Photovoltaic System},
  journal = {IPS Journal of Engineering and Technology},
  year = {2026},
  volume = {2},
  number = {2},
  pages = {261--276},
  doi = {10.54117/1dxqck90}
}
Kostenlos starten →