EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Preparation and Performance Study of Ultra-lightweight In-situ Self-foaming Composite Insulation Cores

Linyao Wu, Yunpeng Liu, Le Li

Academic Journal of Science and Technology · 24.04.2026 · 20 (3) · 51-59

DOI: 10.54097/5syhks40 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Academic Journal of Science and Technology, online erschienen am 24.04.2026. Verfasst von Linyao Wu und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

To achieve the lightweighting of pillar composite insulators, this study employs an in-situ self-foaming molding process to prepare expandable microsphere/epoxy composite insulation core materials. Using DU658 expandable microspheres as fillers and E-51 epoxy resin as the matrix, the core density was controlled at 0.35 g/cm3. Four types of specimens with resin mass fractions of 55%, 60%, 65%, and 70% were prepared. The effects of resin content on microscopic morphology (SEM), chemical structure (FT-IR), interfacial properties (dye penetration), thermal properties (DSC, TG, DMA), and power frequency breakdown strength were systematically investigated. Results indicate that resin content influences cell size and distribution by regulating the expansion space of microspheres and the matrix constraint. The 55% resin group exhibited the smallest cells with a concentrated distribution; the 65% group had the largest cell size and highest dispersion; the 70% group's cell distribution tended toward concentration again due to enhanced matrix encapsulation. FTIR testing confirmed that only physical bonding exists between the microspheres and the resin, with no chemical reaction. All specimens passed the dye penetration test, showing tight interfacial bonding. Regarding thermal properties, DSC results showed that the glass transition temperature increased from 85 ℃ to 109 ℃ with increasing resin content. TG analysis indicated that the initial decomposition temperature (T5%) of all specimens was above 192 ℃, making them suitable for long-term service below 200 ℃. DMA results showed the 60% resin group had the highest initial storage modulus (1250 MPa), satisfying rigidity requirements. Breakdown performance tests revealed a downward trend in power frequency breakdown strength as resin content increased; however, the breakdown strength of all specimens exceeded 30 kV/cm, meeting electrical standards, with the 55% resin group performing best. This study provides an experimental basis for the formulation and process optimization of lightweight insulation cores for UHV/EHV insulators.

Zitieren

APA

Wu, L., Liu, Y., & Li, L. (2026). Preparation and Performance Study of Ultra-lightweight In-situ Self-foaming Composite Insulation Cores. Academic Journal of Science and Technology, 20(3), 51-59. https://doi.org/10.54097/5syhks40

Vancouver

Wu L, Liu Y, Li L. Preparation and Performance Study of Ultra-lightweight In-situ Self-foaming Composite Insulation Cores. Academic Journal of Science and Technology. 2026;20(3):51-59. doi:10.54097/5syhks40

BibTeX
@article{Wu2026,
  author = {Wu, Linyao and Liu, Yunpeng and Li, Le},
  title = {Preparation and Performance Study of Ultra-lightweight In-situ Self-foaming Composite Insulation Cores},
  journal = {Academic Journal of Science and Technology},
  year = {2026},
  volume = {20},
  number = {3},
  pages = {51--59},
  doi = {10.54097/5syhks40}
}
Kostenlos starten →