EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Effects of surrounding and underlying shades on the color adjustment potential of a single-shade composite used in a thin layer

Mariana Silva Barros iD, Paula Fernanda Damasceno Silva iD, Márcia Luciana Carregosa Santana iD, Rafaella Mariana Fontes Bragança iD, André Luis Faria-E-Silva iD

Restorative Dentistry & Endodontics · 2023 · 48 (1)

DOI: 10.5395/rde.2023.48.e7 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Restorative Dentistry & Endodontics, 2023. Verfasst von Mariana Silva Barros und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Dentistry, Federal University of Sergipe, Aracaju, SE, Brazil. Die Arbeit wurde bisher 17-mal zitiert (Crossref) und nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: Improvement of Higher Educational Personnel.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Objectives

This study aimed to evaluate the surrounding and underlying shades' effect on the color adjustment potential (CAP) of a single-shade composite used in a thin layer. Materials and Methods: Cylinder specimens (1.0 mm thick) were built with the Vittra APS Unique composite, surrounded (dual specimens) or not (simple specimens) by a control composite (shade A1, A2, or A3). Simple specimens were also built only with the control composites. Each specimen's color was measured against white and black backgrounds or the simple control specimens with a spectrophotometer (CIELAB system). The whiteness index for dentistry (WID) and translucency parameters (TP00) were calculated for simple specimens. Differences (ΔE00) in color between the simple/dual specimens and the controls were calculated. The CAP was calculated based on the ratios between data from simple and dual specimens.

Results

The Vittra APS Unique composite showed higher WID and TP00 values than the controls. The highest values of ΔE00 were observed among simple specimens. The color measurements of Vittra APS Unique (simple or dual) against the control specimens presented the lowest color differences. Only surrounding the single-shade composite with a shaded composite barely impacted the ΔE00. The highest CAP values were obtained using a shaded composite under simple or dual specimens.

Conclusions

The CAP of Vittra APS Unique was strongly affected by the underlying shade, while surrounding this composite with a shaded one barely affected its color adjustment.

Schlagwörter

Stichwörter der Autor:innen

ColorComposite resinsDental materialsDental restoration, PermanentEsthetics, Dental

Autor:innen und Institutionen

  • Department of Dentistry, Federal University of Sergipe, Aracaju, SE, Brazil.

ORCID-Profile: Mariana Silva Barros, Paula Fernanda Damasceno Silva, Márcia Luciana Carregosa Santana, Rafaella Mariana Fontes Bragança, André Luis Faria-E-Silva

Förderung

  • Improvement of Higher Educational Personnel

Zitieren

APA

Barros, M. S., Silva, P. F. D., Santana, M. L. C., Bragança, R. M. F., & Faria-E-Silva, A. L. (2023). Effects of surrounding and underlying shades on the color adjustment potential of a single-shade composite used in a thin layer. Restorative Dentistry & Endodontics, 48(1). https://doi.org/10.5395/rde.2023.48.e7

Vancouver

Barros MS, Silva PFD, Santana MLC, Bragança RMF, Faria-E-Silva AL. Effects of surrounding and underlying shades on the color adjustment potential of a single-shade composite used in a thin layer. Restorative Dentistry & Endodontics. 2023;48(1). doi:10.5395/rde.2023.48.e7

BibTeX
@article{Barros2023,
  author = {Barros, Mariana Silva and Silva, Paula Fernanda Damasceno and Santana, Márcia Luciana Carregosa and Bragança, Rafaella Mariana Fontes and Faria-E-Silva, André Luis},
  title = {Effects of surrounding and underlying shades on the color adjustment potential of a single-shade composite used in a thin layer},
  journal = {Restorative Dentistry & Endodontics},
  year = {2023},
  volume = {48},
  number = {1},
  doi = {10.5395/rde.2023.48.e7}
}
Kostenlos starten →