EUVIMEDEUVIMED entdecken
Crossref

Analyzing the Effects of Cutting Parameters on Machinability Criteria in Milling of 17-4PH Stainless Steel under Dry Environment

Hakan YURTKURAN, Mustafa GÜNAY

İmalat Teknolojileri ve Uygulamaları · 2022

DOI: 10.52795/mateca.1181213 ↗

Kurz gefasst

Fachartikel in der Zeitschrift İmalat Teknolojileri ve Uygulamaları, 2022. Verfasst von Hakan YURTKURAN und 1 weiteren Autor:innen. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 1 Literaturangaben. Gefördert von: TÜBİTAK 2209-A.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

17-4 PH steel is a martensitic precipitation hardening stainless steel with an excellent convenience of good corrosion resistance and high mechanical properties. At the same time, it has been determined from the literature that very little research has been done on the milling of this steel, which is one of the materials that are difficult to process. Therefore, an experimental research was focused on the milling of the steel with coated carbide inserts in a dry cutting environment, which is an eco-friendly cutting regime. In the experiments performed with the up milling technique, the changes in the resultant cutting force (Fr), surface roughness (Ra) and total cutting power or energy consumption (PcT) during machining were investigated. Experiments were performed according to the L9 experimental design by choosing three different cutting speeds (V), feed rate (f) and cutting depth (ap). Fr values were calculated with the help of cutting force components measured with Kistler brand dynamometer and equipment. The magnitude of Fr mostly depends on the cutting depth (64.92%) and then the feed rate (30.26%), and it was determined that the forces relatively decreased with the increase in cutting speed. While Ra was mainly affected by the feed rate (65.52%), it was observed that the cutting speed had a substantial positive effect (33.78%). According to the PcT results, although the energy consumption owing to the spindle speed increased at high cutting speed without changing the chip cross-section, the decrease in material strength as a result of the increased cutting temperature led to a decrease in the total energy consumption. However, the lowest value was obtained at the smallest levels of the machining parameters. In the light of all the results, it is recommended to use optimized cutting parameters in industrial applications in terms of contributing to sustainability.

Förderung

  • TÜBİTAK 2209-A

Zitieren

APA

YURTKURAN, H., & GÜNAY, M. (2022). Analyzing the Effects of Cutting Parameters on Machinability Criteria in Milling of 17-4PH Stainless Steel under Dry Environment. İmalat Teknolojileri ve Uygulamaları. https://doi.org/10.52795/mateca.1181213

Vancouver

YURTKURAN H, GÜNAY M. Analyzing the Effects of Cutting Parameters on Machinability Criteria in Milling of 17-4PH Stainless Steel under Dry Environment. İmalat Teknolojileri ve Uygulamaları. 2022. doi:10.52795/mateca.1181213

BibTeX
@article{YURTKURAN2022,
  author = {YURTKURAN, Hakan and GÜNAY, Mustafa},
  title = {Analyzing the Effects of Cutting Parameters on Machinability Criteria in Milling of 17-4PH Stainless Steel under Dry Environment},
  journal = {İmalat Teknolojileri ve Uygulamaları},
  year = {2022},
  doi = {10.52795/mateca.1181213}
}
Kostenlos starten →