EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Dry Copper-Foil Fabrication of a 10 GHz Microstrip Patch Antenna for Rapid 6G FR3 Antenna Prototyping

Rahmat Bin Abdul Wahid, Zeti Akma Rhazali

Journal of Energy and Sustainable Environment · 2026

DOI: 10.52650/gkbmtk85 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Energy and Sustainable Environment, 2026. Verfasst von Rahmat Bin Abdul Wahid und 1 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study presents the design, fabrication, and validation of a 10 GHz rectangular microstrip patch antenna using a dry copper-foil fabrication route. The work is motivated by the growing interest in Frequency Range 3 (FR3) for future 6G wireless research and the need for faster and lower-waste antenna prototyping methods. The antenna was designed and optimised in CST Studio Suite using Rogers RT/duroid 5880 as the substrate. The original copper cladding on the substrate was removed, and both the radiating patch and ground plane were fabricated using adhesive copper foil. The copper-foil pattern was produced using a computer-controlled cutting plotter and laminated onto the substrate without wet chemical etching. The fabricated antenna was then measured using a vector network analyser to evaluate its reflection coefficient response. The simulated antenna resonated at approximately 10.034 GHz, while the fabricated prototype produced a measured resonance at 10.143 GHz with a minimum S11 of −18.14 dB. The frequency shift between simulation and measurement was approximately 1.09%. These results show that the dry copper-foil process can reproduce the intended input-matching behaviour of a 10 GHz microstrip patch antenna with acceptable agreement. The proposed route is suitable for rapid FR3 antenna prototyping and may support future work on sustainable RF front-end systems.

Zitieren

APA

Wahid, R. B. A., & Rhazali, Z. A. (2026). Dry Copper-Foil Fabrication of a 10 GHz Microstrip Patch Antenna for Rapid 6G FR3 Antenna Prototyping. Journal of Energy and Sustainable Environment. https://doi.org/10.52650/gkbmtk85

Vancouver

Wahid RBA, Rhazali ZA. Dry Copper-Foil Fabrication of a 10 GHz Microstrip Patch Antenna for Rapid 6G FR3 Antenna Prototyping. Journal of Energy and Sustainable Environment. 2026. doi:10.52650/gkbmtk85

BibTeX
@article{Wahid2026,
  author = {Wahid, Rahmat Bin Abdul and Rhazali, Zeti Akma},
  title = {Dry Copper-Foil Fabrication of a 10 GHz Microstrip Patch Antenna for Rapid 6G FR3 Antenna Prototyping},
  journal = {Journal of Energy and Sustainable Environment},
  year = {2026},
  doi = {10.52650/gkbmtk85}
}
Kostenlos starten →