ESTUDO DA VIABIBILIDADE DO EMPREGO DE PÓ DE MÁRMORE PARA PRODUÇÃO DE CONCRETO AUTO-ADENSÁVEL E SUBSTITUIÇÃO PARCIAL DOS AGREGADOS POR PÉROLAS DE POLIESTIRENO EXPANDIDO (EPS)
REEC - Revista Eletrônica de Engenharia Civil · 2015
DOI: 10.5216/reec.v10i2.33117 ↗Kurz gefasst
Fachartikel in der Zeitschrift REEC - Revista Eletrônica de Engenharia Civil, 2015. Verfasst von Rosemarie Kumayama und 3 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref).
Abstract (Originalsprache)
RESUMO: Este trabalho estuda a viabilidade tecnica da utilizacao do po de marmore como finos na confeccao de concreto autoadensavel (CAA), juntamente com a substituicao de parte dos agregados graudos e miudos por poliestireno expandido (EPS). Adotando a relacao filer-cimento igual a 0,15, foi otimizada uma composicao de referencia sem a substituicao de EPS, e para fins de comparacao foram otimizadas composicoes com substituicao, adotando-se as porcentagens de 10%, 20%, 30% e 40% em substituicao. Alguns ensaios foram realizados no estado fresco para fins da validacao do CAA, e no estado endurecido para a avaliacao do desempenho em funcao das substituicoes. Os ensaios no estado fresco incluiam os seguintes: Slump Flow Test, Slump Flow T50 Test, V- Funnel Test, L- Box Test, Ensaio de Peneiramento, e Ensaio da Massa Especifica Aparente. No estado endurecido foram realizados os ensaios de avaliacao da resistencia a compressao simples e da resistencia a compressao diametral, alem dos ensaios de absorcao d’agua. Dos ensaios no estado fresco observou-se influencias no sentido de que a incorporacao gradativa de isopor junto ao po de marmore contribuiu para o aumento dos valores das propriedades que dependem da viscosidade do concreto, de modo a minimizar os efeitos de segregacao e de exsudacao, compensado a baixa retencao de agua pelo po de marmore. Os resultados no estado fresco se apresentaram de modo a validar as propriedades requeridas para o CAA. No estado endurecido observou-se a diminuicao dos valores de resistencia a compressao simples e diametral, e o aumento dos valores da absorcao, com o incremento do teor de EPS em substituicao. Percebeu-se que a variacao dos valores das propriedades mecânicas se deu de modo aproximadamente linear, oferecendo o indicativo de um modelo previsional para a variacao do comportamento mecânico, quando considerado o teor de EPS adotado em substituicao. ABSTRACT: This work studies the technical feasibility of using marble dust as fine in the manufacture of self-compacting concrete (SCC), along with the replacement of the coarse aggregates and kids for expanded polystyrene (EPS). Adopting the filler-cement ratio of 0.15 was optimal a reference composition without the EPS substitution and replacement purposes of comparison with compositions were optimized, taking up the percentages of 10%, 20%, 30% and 40% in place. Some assays were carried out in the fresh state for the purpose of validation of CAA and in hardened condition for evaluating the performance for substitutions. Trials in the fresh state included the following: Slump Flow Test, T50 Slump Flow Test, V- Funnel Test, L-Box Test, Screening Test, and Test of Density Apparent. In the hardened state were conducted assessment tests of the compressive strength and diametrical compressive strength, in addition to water absorption tests. From tests in fresh influence was observed in the sense that the gradual incorporation of polystyrene with the marble dust contributed to the increase of the property values that depend on the concrete viscosity in order to minimize the effects of segregation and exudation, offset the low water retention by marble dust. The results presented in the natural state in order to validate the properties required for the CAA, in the hardened state there was a decrease in the simple and diametrical compression strength values, and the increase in absorption values, with the increase of content EPS in place. It was noticed that the variation in the mechanical property values given are approximately linearly, providing the indication of a forward model for the variation of the mechanical behavior when considered EPS content adopted instead.
Zitieren
APA
Kumayama, R., Alcântara, M. A. D. M., Cruz, W. D. S., & Segantini, A. A. D. S. (2015). ESTUDO DA VIABIBILIDADE DO EMPREGO DE PÓ DE MÁRMORE PARA PRODUÇÃO DE CONCRETO AUTO-ADENSÁVEL E SUBSTITUIÇÃO PARCIAL DOS AGREGADOS POR PÉROLAS DE POLIESTIRENO EXPANDIDO (EPS). REEC - Revista Eletrônica de Engenharia Civil. https://doi.org/10.5216/reec.v10i2.33117
Vancouver
Kumayama R, Alcântara MADM, Cruz WDS, Segantini AADS. ESTUDO DA VIABIBILIDADE DO EMPREGO DE PÓ DE MÁRMORE PARA PRODUÇÃO DE CONCRETO AUTO-ADENSÁVEL E SUBSTITUIÇÃO PARCIAL DOS AGREGADOS POR PÉROLAS DE POLIESTIRENO EXPANDIDO (EPS). REEC - Revista Eletrônica de Engenharia Civil. 2015. doi:10.5216/reec.v10i2.33117
BibTeX
@article{Kumayama2015,
author = {Kumayama, Rosemarie and Alcântara, Marco Antonio De Morais and Cruz, Willian Da Silva and Segantini, Antonio Anderson da Silva},
title = {ESTUDO DA VIABIBILIDADE DO EMPREGO DE PÓ DE MÁRMORE PARA PRODUÇÃO DE CONCRETO AUTO-ADENSÁVEL E SUBSTITUIÇÃO PARCIAL DOS AGREGADOS POR PÉROLAS DE POLIESTIRENO EXPANDIDO (EPS)},
journal = {REEC - Revista Eletrônica de Engenharia Civil},
year = {2015},
doi = {10.5216/reec.v10i2.33117}
}
EUVIMED