Economic Aspects of Minimum Quantity Lubrication (MQL) in Milling of Magnesium Alloy
Communications of the IBIMA · 19.03.2026
DOI: 10.5171/2025.4623725 ↗Kurz gefasst
Fachartikel in der Zeitschrift Communications of the IBIMA, online erschienen am 19.03.2026. Verfasst von Kamil P. WASZCZUK und 1 weiteren Autor:innen.
Abstract (Originalsprache)
This paper examines the applicability of minimum quantity lubrication (MQL) in the milling of magnesium alloys. The experimental procedure involved the progressive introduction of additional MQL nozzles to assess the influence of the aerosol on surface roughness and production costs. The results indicate that increasing the number of dosing nozzles does not yield a significant improvement in surface quality, while it markedly increases manufacturing costs. Furthermore, it was observed that dry machining, conducted without any coolant, leads to higher surface roughness values. These findings support the application of MQL in the milling of magnesium alloys as an effective compromise between surface quality and economic efficiency.
Zitieren
APA
WASZCZUK, K. P., & FENC, R. (2026). Economic Aspects of Minimum Quantity Lubrication (MQL) in Milling of Magnesium Alloy. Communications of the IBIMA. https://doi.org/10.5171/2025.4623725
Vancouver
WASZCZUK KP, FENC R. Economic Aspects of Minimum Quantity Lubrication (MQL) in Milling of Magnesium Alloy. Communications of the IBIMA. 2026. doi:10.5171/2025.4623725
BibTeX
@article{WASZCZUK2026,
author = {WASZCZUK, Kamil P. and FENC, Rafal},
title = {Economic Aspects of Minimum Quantity Lubrication (MQL) in Milling of Magnesium Alloy},
journal = {Communications of the IBIMA},
year = {2026},
doi = {10.5171/2025.4623725}
}
EUVIMED