Multi-Objective Optimization of the Turning Process using the Probability Method
Engineering, Technology & Applied Science Research · 02.02.2025 · 15 (1) · 19865-19870
DOI: 10.48084/etasr.9472 ↗Kurz gefasst
Fachartikel in der Zeitschrift Engineering, Technology & Applied Science Research, online erschienen am 02.02.2025. Verfasst von Tran Van Dua und 4 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This research aims to determine the optimal values of the cutting parameters when solving the turning process multi-objective problem. Three cutting parameters are considered in this study: spindle speed (nw), feed rate (f), and depth of cut (ap). A turning experiment series was conducted on a conventional lathe, with nine experiments having been designed according to the Taguchi experimental design matrix. In each experiment, the values of the three parameters changed and the material Removal Rate (Q) was measured. The Probability method was used to solve the multi-objective optimization problem. The Method based on the Removal Effects of Criteria (MEREC) technique was employed to calculate the weights of the criteria. The results of the optimization problem using the Probability method were also compared with those obtained using other methods, including the Simple Additive Weighting (SAW), Technique for Order Preference by Similarity to Ideal Solution (TOPSIS), Vlsekriterijumska optimizacijaI KOmpromisno Resenje (VIKOR), Multi-Atributive Ideal-Real Comparative Analysis (MAIRCA), Evaluation by an Area-based Method for Ranking (EAMR), Complex Proportional Assessment (COPRAS), Measurement Alternatives and Ranking according to Compromise Solution (MARCOS), Proximity Indexed Value (PIV), and Combined Compromise Solution (COCOSO). All the methods converged on the same unique solution to the multi-objective optimization problem. The optimal values for the parameters were: nw = 1350 rev/min, corresponding to a feed rate of 0.13 mm/rev, and a depth of cut of 0.4 mm. When machining with these optimal cutting parameters, the resulting values for Ra, RE, and Q were 1.057 µm, 0.03 mm, and 13225.68 mm²/min, respectively.
Zitieren
APA
Dua, T. V., Thinh, H. X., Bao, N. C., Duc, D. V., & Hoang, T. M. (2025). Multi-Objective Optimization of the Turning Process using the Probability Method. Engineering, Technology & Applied Science Research, 15(1), 19865-19870. https://doi.org/10.48084/etasr.9472
Vancouver
Dua TV, Thinh HX, Bao NC, Duc DV, Hoang TM. Multi-Objective Optimization of the Turning Process using the Probability Method. Engineering, Technology & Applied Science Research. 2025;15(1):19865-19870. doi:10.48084/etasr.9472
BibTeX
@article{Dua2025,
author = {Dua, Tran Van and Thinh, Hoang Xuan and Bao, Nguyen Chi and Duc, Duong Van and Hoang, Tran Minh},
title = {Multi-Objective Optimization of the Turning Process using the Probability Method},
journal = {Engineering, Technology & Applied Science Research},
year = {2025},
volume = {15},
number = {1},
pages = {19865--19870},
doi = {10.48084/etasr.9472}
}
EUVIMED