EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

A New Parametric Indirect Reverse Engineering Method for Screw Compressor Profile Generation

Van Thuong Nguyen, Van Son Pham, Long Hoang

Engineering, Technology & Applied Science Research · 11.08.2026 · 16 (4) · 38238-38247

DOI: 10.48084/etasr.19708 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Engineering, Technology & Applied Science Research, online erschienen am 11.08.2026. Verfasst von Van Thuong Nguyen und 2 weiteren Autor:innen. Die Arbeit nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Reverse Engineering (RE) of an air compressor screw pair (male and female rotors) is often used to reproduce a degraded screw pair or to analyze its performance. However, RE is time-consuming and leads to profile deviation in the transverse cross-section of the male and female screws. In addition, the traditional RE approach does not employ the meshing and the original mathematical equation of the profiles. These limitations result in imperfect interaction between male and female screws, creating a sealed chamber for gas compression without mechanical binding. To address these limitation this study proposes the Parametric Indirect Reverse-Engineering (PIRE) method that consists of three main steps: (i) obtaining and parameterizing RE data of the male rotor profile based on epicycloid and circular arc segments, while minimizing the sum of squared deviations; (ii) generating conjugate female rotor profiles based on the meshing equations with verification for undercut conditions; (iii) numerical analysis to evaluate the effectiveness of the reconstructed rotor profiles. Numerical simulations were performed on the Airman PDS50 air compressor using the RE and PIRE rotor profiles. The simulation results indicate that, compared to the RE profile, the proposed PIRE rotor profile reduces the transmission ratio error from approximately 6% to 0.7%, increases the internal pressure by approximately 5%, increases the predicted mass flow rate by 6.5%, and improves the volumetric efficiency from 71.2% to 75.6%.

Zitieren

APA

Nguyen, V. T., Pham, V. S., & Hoang, L. (2026). A New Parametric Indirect Reverse Engineering Method for Screw Compressor Profile Generation. Engineering, Technology & Applied Science Research, 16(4), 38238-38247. https://doi.org/10.48084/etasr.19708

Vancouver

Nguyen VT, Pham VS, Hoang L. A New Parametric Indirect Reverse Engineering Method for Screw Compressor Profile Generation. Engineering, Technology & Applied Science Research. 2026;16(4):38238-38247. doi:10.48084/etasr.19708

BibTeX
@article{Nguyen2026,
  author = {Nguyen, Van Thuong and Pham, Van Son and Hoang, Long},
  title = {A New Parametric Indirect Reverse Engineering Method for Screw Compressor Profile Generation},
  journal = {Engineering, Technology & Applied Science Research},
  year = {2026},
  volume = {16},
  number = {4},
  pages = {38238--38247},
  doi = {10.48084/etasr.19708}
}
Kostenlos starten →