The Effect of SiC Powder-Mixed Dielectric Fluid on Electrical Discharge Machining Using the Taguchi Method
Engineering, Technology & Applied Science Research · 06.06.2026 · 16 (3) · 37085-37092
DOI: 10.48084/etasr.18644 ↗Kurz gefasst
Fachartikel in der Zeitschrift Engineering, Technology & Applied Science Research, online erschienen am 06.06.2026. Verfasst von Patittar Nakwong und 1 weiteren Autor:innen. Die Arbeit nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This study employs the Taguchi L9 orthogonal array to evaluate the effects of Silicon Carbide (SiC) powder addition (4 g/L, 6.3 µm particle size) in die-sinking Electrical Discharge Machining (EDM) of SKD11 tool steel by using a brass electrode. Three parameters were investigated at three levels: peak current (15–24 A), Duty Factor (DF) (60–80%), and electrode servo feed rate (120–180 mm/min). The results showed that SiC Powder-Mixed EDM (PMEDM) improved the Material Removal Rate (MRR) by approximately 9.51% and increased the regression model accuracy from an adjusted R² of 82.28% to 91.79% compared to conventional EDM. Surface microhardness increased from 720 HV to 850 HV, while white layer thickness increased from 8.5 μm to 12.3 μm. However, Surface Roughness (SR) (Ra) deteriorated under PMEDM conditions. DF was identified as the most influential parameter affecting both MRR and SR, whereas servo feed rate showed minimal influence. The study demonstrates that SiC-PMEDM enhances machining efficiency and surface hardening, but introduces a trade-off with surface quality, providing useful guidance for parameter optimization in rough machining applications of hardened tool steels.
Zitieren
APA
Nakwong, P., & Muttamara, A. (2026). The Effect of SiC Powder-Mixed Dielectric Fluid on Electrical Discharge Machining Using the Taguchi Method. Engineering, Technology & Applied Science Research, 16(3), 37085-37092. https://doi.org/10.48084/etasr.18644
Vancouver
Nakwong P, Muttamara A. The Effect of SiC Powder-Mixed Dielectric Fluid on Electrical Discharge Machining Using the Taguchi Method. Engineering, Technology & Applied Science Research. 2026;16(3):37085-37092. doi:10.48084/etasr.18644
BibTeX
@article{Nakwong2026,
author = {Nakwong, Patittar and Muttamara, Apiwat},
title = {The Effect of SiC Powder-Mixed Dielectric Fluid on Electrical Discharge Machining Using the Taguchi Method},
journal = {Engineering, Technology & Applied Science Research},
year = {2026},
volume = {16},
number = {3},
pages = {37085--37092},
doi = {10.48084/etasr.18644}
}
EUVIMED