EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Optimization of Small-Hole Drilling Parameters in Electrical Discharge Machining Using Grey Relational Analysis

Tavee Madsa, Kamonpong Jamkamon

Engineering, Technology & Applied Science Research · 04.04.2026 · 16 (2) · 33776-33782

DOI: 10.48084/etasr.17211 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Engineering, Technology & Applied Science Research, online erschienen am 04.04.2026. Verfasst von Tavee Madsa und 1 weiteren Autor:innen. Die Arbeit nennt 19 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study presents an optimization technique for the machining conditions of the small-hole Electrical Discharge Machining (EDM) drilling process. Performance characteristics, such as the Material Removal Rate (MRR) and Electrode Wear Ratio (EWR), were evaluated using Grey Relational Analysis (GRA). A One-Factor-At-a-Time (OFAT) experimental design was employed for testing on SKD61 tool steel, with a brass tube tool electrode of 1 mm outer diameter . The control machining conditions consisted of discharge current, pulse-on time, and pulse-off time. Multiresponse optimization was identified with GRA at a discharge current of 25.5 A, a pulse-on time of 70 µs, and a pulse-off time of 10 µs. The Grey Relational Grade (GRG) improved by approximately 23.79%. The mean MRR and EWR were 5.3484 mm³/min and 2.3139 mm³/min with prediction errors of 6.51% and 7.55%, respectively. Scanning Electron Microscopy (SEM) revealed that electrode wear mainly occurred at the corners and end face of the tubular electrode, resulting in a tapered tool tip and, correspondingly, a tapered drilled hole. The findings suggest that applying optimization parameters using OFAT is feasible with the GRA. In addition, the latter constitutes a robust methodology for multiresponse optimization. The study did not employ any specialized commercial software, demonstrating the utility of GRA in a wide range of manufacturing operations.

Zitieren

APA

Madsa, T., & Jamkamon, K. (2026). Optimization of Small-Hole Drilling Parameters in Electrical Discharge Machining Using Grey Relational Analysis. Engineering, Technology & Applied Science Research, 16(2), 33776-33782. https://doi.org/10.48084/etasr.17211

Vancouver

Madsa T, Jamkamon K. Optimization of Small-Hole Drilling Parameters in Electrical Discharge Machining Using Grey Relational Analysis. Engineering, Technology & Applied Science Research. 2026;16(2):33776-33782. doi:10.48084/etasr.17211

BibTeX
@article{Madsa2026,
  author = {Madsa, Tavee and Jamkamon, Kamonpong},
  title = {Optimization of Small-Hole Drilling Parameters in Electrical Discharge Machining Using Grey Relational Analysis},
  journal = {Engineering, Technology & Applied Science Research},
  year = {2026},
  volume = {16},
  number = {2},
  pages = {33776--33782},
  doi = {10.48084/etasr.17211}
}
Kostenlos starten →