EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Synthesis of Ternary Chitosan–Al₂O₃–Graphene Oxide Composite via Sol-Gel Method for Enhanced Adsorptive Removal of Methylene Blue: Characterization, Kinetics, and Isotherm Studies

Desnelli Desnelli, Fenti Apriyani, Daniel Alfarado, Eva Musifa, Muhammad Said, Ady Mara, Suheryanto Suheryanto, Wiwien Andriyanti, Bayu Mardi Kartika

Trends in Sciences · 20.08.2026 · 24 (1) · 14436

DOI: 10.48048/tis.2027.14436 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Trends in Sciences, online erschienen am 20.08.2026. Verfasst von Desnelli Desnelli und 8 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The rapid growth of the textile industry has worsened water pollution with the release of synthetic dyes, especially methylene blue, which presents significant environmental and health risks due to its persistence against natural degradation. Graphene oxide (GO) has been proposed as a promising adsorbent. However, its practical application is constrained by post-treatment separation and secondary pollution, which can impede the overall effectiveness of employing GO in water treatment processes. The aim of this research was to synthesize a ternary composite of chitosan–Al₂O₃–graphene oxide (CS–AO–GO) via the sol-gel method for enhanced adsorptive removal of methylene blue and improved separation. The composite was prepared by adding GO and Al₂O₃ into the chitosan matrix with various mass ratios, and the ratio 1:3 (CS–AO–GO 1:3) was selected for detailed investigation due to its smaller crystal size. XRD characterization confirmed the successful incorporation of all 3 components. SEM-EDX revealed a porous heterogeneous surface morphology with elemental verification of carbon, nitrogen, oxygen and aluminum. BET analysis showed a significant enhancement in the specific surface area from 7.036 m²/g for pure chitosan to 23.009 m²/g for the composite, which had a mesoporous structure with an average pore size of 13.106 nm. Based on the batch adsorption study, the optimum conditions for methylene blue were obtained at pH 9, contact time 50 min and initial concentration 45 mg/L with an adsorption capacity of 10.817 mg/g and removal efficiency of 80.12%. The Langmuir isotherm model provided a good fit to the adsorption equilibrium data (R² = 0.998), indicating monolayer adsorption on a homogeneous surface with a maximum adsorption capacity of 11.600 mg/g. Kinetic studies showed that the adsorption process was found to follow a pseudo-second-order model (R² = 0.982), indicating that the rate-limiting step was controlled by chemisorption mechanisms such as electrostatic interaction, complex formation and π-π interaction. Results showed that the incorporation of Al₂O₃ and GO into the chitosan matrix significantly improved the surface area and adsorption efficiency, reaching almost six times as compared to pure chitosan. The synthesized CS–AO–GO composite is a promising and cost-effective and easily separable biopolymer-based adsorbent for the remediation of cationic dye-contaminated textile wastewater. HIGHLIGHTS A novel ternary composite made up of chitosan, Al₂O₃, and graphene oxide was successfully synthesized using a straightforward sol-gel method The incorporation of Al₂O₃ and graphene oxide significantly enhanced the thermal stability and surface properties of chitosan The composite exhibited high adsorption capacity for methylene blue, outperforming pristine chitosan and binary composites GRAPHICAL ABSTRACT

Zitieren

APA

Desnelli, D., Apriyani, F., Alfarado, D., Musifa, E., Said, M., Mara, A., Suheryanto, S., Andriyanti, W., & Kartika, B. M. (2026). Synthesis of Ternary Chitosan–Al₂O₃–Graphene Oxide Composite via Sol-Gel Method for Enhanced Adsorptive Removal of Methylene Blue: Characterization, Kinetics, and Isotherm Studies. Trends in Sciences, 24(1), 14436. https://doi.org/10.48048/tis.2027.14436

Vancouver

Desnelli D, Apriyani F, Alfarado D, Musifa E, Said M, Mara A, et al. Synthesis of Ternary Chitosan–Al₂O₃–Graphene Oxide Composite via Sol-Gel Method for Enhanced Adsorptive Removal of Methylene Blue: Characterization, Kinetics, and Isotherm Studies. Trends in Sciences. 2026;24(1):14436. doi:10.48048/tis.2027.14436

BibTeX
@article{Desnelli2026,
  author = {Desnelli, Desnelli and Apriyani, Fenti and Alfarado, Daniel and Musifa, Eva and Said, Muhammad and Mara, Ady and Suheryanto, Suheryanto and Andriyanti, Wiwien and Kartika, Bayu Mardi},
  title = {Synthesis of Ternary Chitosan–Al₂O₃–Graphene Oxide Composite via Sol-Gel Method for Enhanced Adsorptive Removal of Methylene Blue: Characterization, Kinetics, and Isotherm Studies},
  journal = {Trends in Sciences},
  year = {2026},
  volume = {24},
  number = {1},
  pages = {14436},
  doi = {10.48048/tis.2027.14436}
}
Kostenlos starten →