Study the impacts of drilling on heat sink efficiency using Solidworks simulation and the response surface method
Journal of Thermal Engineering · 29.07.2026
DOI: 10.47481/jten.0076 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Thermal Engineering, online erschienen am 29.07.2026. Verfasst von Dara Khalid Khidhir und 7 weiteren Autor:innen.
Abstract (Originalsprache)
Heat sinks are vital components for preventing overheating in electronic devices, and perfecting their performance is a key challenge due to their compact design and the need for effective heat dissipation. This paper aims to use experimentally validated simulations in SolidWorks (2023) to improve their cooling efficiency by evaluating shape factors of three designs: square, circular, and elliptical. The response surface method was used to assess the combined effects of drilling parameters (diameter, depth, and number of holes) on performance optimization. The results showed that the square shape was superior because its temperature was 44°C and 34°C lower than those of the circular and elliptical shapes, respectively. The highest Nusselt number and the lowest thermal resistance further confirmed the superiority of the square design. Additionally, drilling 195 holes of 1.5 mm diameter through the entire thickness (30 mm) of the heat sink further reduced the temperature by 19 °C compared to an undrilled square heat sink. Drilling with these dimensions increased the exposed surface area and decreased the thermally stored mass by 13.15 %, which provides a physical explanation for the observed improvements. While existing literature discusses the roles of drilling and shape factors, no studies have examined their combined influence specifically in the core of heat sinks. This study aims to integrate numerical analyses and experimental findings using statistical methods, thereby extending current research and highlighting the novelty of this work. The findings inspire engineers to develop eco-efficient passive cooling systems for electronic devices.
Zitieren
APA
Khidhir, D. K., Talabani, S. S. M., Azeez, A. T., Salih, Z. Q., Wali, S., Zuber, H., Ali, C., & Naje, M. (2026). Study the impacts of drilling on heat sink efficiency using Solidworks simulation and the response surface method. Journal of Thermal Engineering. https://doi.org/10.47481/jten.0076
Vancouver
Khidhir DK, Talabani SSM, Azeez AT, Salih ZQ, Wali S, Zuber H, et al. Study the impacts of drilling on heat sink efficiency using Solidworks simulation and the response surface method. Journal of Thermal Engineering. 2026. doi:10.47481/jten.0076
BibTeX
@article{Khidhir2026,
author = {Khidhir, Dara Khalid and Talabani, Serwan S. Mohammed and Azeez, Ahmed T. and Salih, Zanyar Q. and Wali, Sana and Zuber, Huda and Ali, Chenar and Naje, Mohsen},
title = {Study the impacts of drilling on heat sink efficiency using Solidworks simulation and the response surface method},
journal = {Journal of Thermal Engineering},
year = {2026},
doi = {10.47481/jten.0076}
}
EUVIMED