Numerical Simulation and Optimization of Airflow Distribution Characteristics in the Air Distribution Chamber of a Needle-type Forage Dryer
Journal of Applied Fluid Mechanics · 01.10.2026 · 19 (10)
DOI: 10.47176/jafm.19.10.4546 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Applied Fluid Mechanics, online erschienen am 01.10.2026. Verfasst von X. T. Liu und 2 weiteren Autor:innen.
Abstract (Originalsprache)
To address uneven air supply among multiple needle tubes during the drying of high-density forage bales, this study investigated the airflow characteristics and structural optimization of the upper and lower air distribution chambers of a needle-type forage dryer. A three-dimensional CFD model was established, and airflow performance was evaluated using the velocity non-uniformity coefficient M and the inlet-to-outlet total pressure drop Δp. Response surface methodology was used to optimize the key structural parameters. For the upper chamber, installation of a T-shaped baffle and optimization of the cavity height Hc, diffuser angle α, and top-plate opening area ratio Ra yielded an optimal combination of Hc = 133.29 mm, α = 12.51°, and Ra = 1.12, reducing M from 11.2264% to 3.3886%. For the lower chamber, a strip-perforated airflow equalizing plate with Hb = 74.82 mm, D = 23.79 mm, and W = 25.03 mm reduced M from 9.8772% to 1.5484%, with Δp of approximately 130 Pa. Mesh-refinement and turbulence-model sensitivity analyses supported the robustness of the numerical predictions. Repeated outlet-velocity measurements yielded mean absolute relative errors of 3.09%–4.58%. Smoke visualization and grayscale analysis further indicated that the optimized structures enhanced airflow diffusion and redistribution. The results provide guidance for air distribution chamber design in needle-type forage dryers.
Zitieren
APA
Liu, X. T., Wang, R. Z., & Ding, T. C. (2026). Numerical Simulation and Optimization of Airflow Distribution Characteristics in the Air Distribution Chamber of a Needle-type Forage Dryer. Journal of Applied Fluid Mechanics, 19(10). https://doi.org/10.47176/jafm.19.10.4546
Vancouver
Liu XT, Wang RZ, Ding TC. Numerical Simulation and Optimization of Airflow Distribution Characteristics in the Air Distribution Chamber of a Needle-type Forage Dryer. Journal of Applied Fluid Mechanics. 2026;19(10). doi:10.47176/jafm.19.10.4546
BibTeX
@article{Liu2026,
author = {Liu, X. T. and Wang, R. Z. and Ding, T. C.},
title = {Numerical Simulation and Optimization of Airflow Distribution Characteristics in the Air Distribution Chamber of a Needle-type Forage Dryer},
journal = {Journal of Applied Fluid Mechanics},
year = {2026},
volume = {19},
number = {10},
doi = {10.47176/jafm.19.10.4546}
}
EUVIMED