Parametric Tolerance Analysis of Mechanical Assembly by Developing Direct Constraint Model in CAD and Cost Competent Tolerance Synthesis
Intelligent Control and Automation · 2010
DOI: 10.4236/ica.2010.11001 ↗Kurz gefasst
Fachartikel in der Zeitschrift Intelligent Control and Automation, 2010. Verfasst von Govindarajalu Jayaprakash und 2 weiteren Autor:innen. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
The objective of tolerance analysis is to check the extent and nature of variation of an analyzed dimension or geometric feature of interest for a given GD & T scheme. The parametric approach to tolerance analysis is based on parametric constraint solving. The accuracy of simulation results is dependent on the userdefined modeling scheme. Once an accurate CAD model is developed, it is integrated with tolerance synthesis model. In order to make it cost competent, it is necessary to obtain the costtolerance relationships. The neural network recently has been reported to be an effective statistical tool for determining relationship between input factors and output responses. This study deals development of direct constraint model in CAD, which is integrated to an optimal tolerance design problem. A backpropagation (BP) network is applied to fit the costtolerance relationship. An optimization method based on Differential Evolution (DE) is then used to locate the combination of controllable factors (tolerances) to optimize the output response (manufacturing cost plus quality loss) using the equations stemming from the trained network. A tolerance synthesis problem for a motor assembly is used to investigate the effectiveness and efficiency of the proposed methodology.
Zitieren
APA
Jayaprakash, G., Sivakumar, K., & Thilak, M. (2010). Parametric Tolerance Analysis of Mechanical Assembly by Developing Direct Constraint Model in CAD and Cost Competent Tolerance Synthesis. Intelligent Control and Automation. https://doi.org/10.4236/ica.2010.11001
Vancouver
Jayaprakash G, Sivakumar K, Thilak M. Parametric Tolerance Analysis of Mechanical Assembly by Developing Direct Constraint Model in CAD and Cost Competent Tolerance Synthesis. Intelligent Control and Automation. 2010. doi:10.4236/ica.2010.11001
BibTeX
@article{Jayaprakash2010,
author = {Jayaprakash, Govindarajalu and Sivakumar, Karuppan and Thilak, Manoharan},
title = {Parametric Tolerance Analysis of Mechanical Assembly by Developing Direct Constraint Model in CAD and Cost Competent Tolerance Synthesis},
journal = {Intelligent Control and Automation},
year = {2010},
doi = {10.4236/ica.2010.11001}
}
EUVIMED