EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Effect of Hatch Spacing on the Microstructure and Mechanical Properties of SA508 Gr.3 Steel Fabricated by Laser Powder Bed Fusion

Yuanjiu Huang, Ho Jin Ryu, Kee-Ahn Lee

Journal of Powder Materials · 28.02.2025 · 32 (1) · 50-58

DOI: 10.4150/jpm.2024.00479 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Powder Materials, erschienen am 28.02.2025. Verfasst von Yuanjiu Huang und 2 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: Korea Institute for Advancement of Technology, National Research Foundation of Korea.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigated the effect of the hatch spacing parameter on the microstructure and mechanical properties of SA508 Gr.3 steel manufactured by laser powder bed fusion (L-PBF) for a nuclear pressure vessel. Materials were prepared with varying hatch spacing (0.04 mm [H4] and 0.06 mm [H6]). The H4 exhibited finer and more uniformly distributed grains, while the H6 showed less porosity and a lower defect fraction. The yield strength of the H4 material was higher than that of the H6 material, but there was a smaller difference between the materials in tensile strength. The measured elongation was 5.65% for the H4 material and 10.41% for the H6 material, showing a significantly higher value for H6. An explanation for this is that although the H4 material had a microstructure of small and uniform grains, it contained larger and more numerous pore defects than the H6 material, facilitating stress concentration and the initiation of microcracks.

Förderung

  • Korea Institute for Advancement of Technology
  • National Research Foundation of Korea

Zitieren

APA

Huang, Y., Ryu, H. J., & Lee, K. (2025). Effect of Hatch Spacing on the Microstructure and Mechanical Properties of SA508 Gr.3 Steel Fabricated by Laser Powder Bed Fusion. Journal of Powder Materials, 32(1), 50-58. https://doi.org/10.4150/jpm.2024.00479

Vancouver

Huang Y, Ryu HJ, Lee K. Effect of Hatch Spacing on the Microstructure and Mechanical Properties of SA508 Gr.3 Steel Fabricated by Laser Powder Bed Fusion. Journal of Powder Materials. 2025;32(1):50-58. doi:10.4150/jpm.2024.00479

BibTeX
@article{Huang2025,
  author = {Huang, Yuanjiu and Ryu, Ho Jin and Lee, Kee-Ahn},
  title = {Effect of Hatch Spacing on the Microstructure and Mechanical Properties of SA508 Gr.3 Steel Fabricated by Laser Powder Bed Fusion},
  journal = {Journal of Powder Materials},
  year = {2025},
  volume = {32},
  number = {1},
  pages = {50--58},
  doi = {10.4150/jpm.2024.00479}
}
Kostenlos starten →