The Effects of Semiconductor Wafer Storage Methods on Aluminum Fluoride Crystal Growth on Aluminum Wire Bond Pads
Journal of Microelectronics and Electronic Packaging · 2025
DOI: 10.4071/001c.138519 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Microelectronics and Electronic Packaging, 2025. Verfasst von Michael Raj Marks. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 22 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Abstract (Originalsprache)
Residual fluorine on Al wire bond pads of semiconductor wafers has been attributed to the reactive plasma etching of passivation dielectric layers during the bond pad opening process employing hydrofluorocarbon gases. Even though the initial fluorine concentration immediately after pad cleaning processes is typically below 5 at.%, the concentration can increase to a few times higher with prolonged wafer storage times. Higher fluorine concentrations on the Al bond pad surface increases the risk of aluminum fluoride crystal growth, resulting in pad discoloration. The impediment of intermetallic compound (IMC) formation during wire bonding caused by aluminum fluoride crystals on the Al bond pad surface acting as an interdiffusion barrier can lead to process, quality and reliability issues with the semiconductor device. Through this work, the mechanism of increase of fluorine concentration on Al bond pads, the mechanism of aluminum fluoride crystal formation, and the prevention methods are better understood. Transmission electron microscopy (TEM) analysis revealed that disruptions in the native Al 2 O 3 layer underneath the aluminum fluoride crystal form paths for Al supply for the crystal formation and growth, forming depletion voids in the Al surface. The chemical composition of the aluminum fluoride crystals has been ascertained by X-ray photoelectron spectroscopy (XPS) to be AlF 3 . A detailed study of the effects of wafer storage methods on fluorine concentration on Al metallization of test wafers confirmed an outgassing-condensation mechanism occurring inside the wafer storage. Three storage-related factors have been found to influence the outgassing of fluorine compounds from the wafer polyimide passivation and condensation of fluorine compounds on the Al bond pads: humidity level, displacement of fluorine outgassing species by N 2 , and restriction of outgassing by wafer interleaf film. At the wafer fabrication site, storage of in-process wafers (in wafer box or wafer carrier) in a N 2 cabinet shows a much higher effectiveness in reducing the fluorine compound condensation on the Al bond pads. At the packaging assembly site, the wafer canister storage methods (wafer canister sealed in moisture-barrier bag (MBB) with desiccant, and wafer canister in N 2 cabinet) provide adequate protection for finished wafers from Al bond pad discoloration. These wafer storage methods have effectively prevented the occurrence of fluorine-induced Al bond pad discoloration over prolonged wafer storage times in both the wafer fabrication and packaging assembly sites.
Zitieren
APA
Marks, M. R. (2025). The Effects of Semiconductor Wafer Storage Methods on Aluminum Fluoride Crystal Growth on Aluminum Wire Bond Pads. Journal of Microelectronics and Electronic Packaging. https://doi.org/10.4071/001c.138519
Vancouver
Marks MR. The Effects of Semiconductor Wafer Storage Methods on Aluminum Fluoride Crystal Growth on Aluminum Wire Bond Pads. Journal of Microelectronics and Electronic Packaging. 2025. doi:10.4071/001c.138519
BibTeX
@article{Marks2025,
author = {Marks, Michael Raj},
title = {The Effects of Semiconductor Wafer Storage Methods on Aluminum Fluoride Crystal Growth on Aluminum Wire Bond Pads},
journal = {Journal of Microelectronics and Electronic Packaging},
year = {2025},
doi = {10.4071/001c.138519}
}
EUVIMED